Whirlpool UXT2030AD Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny Whirlpool UXT2030AD. Whirlpool UXT2030AD 28 stron. 30" (76.2 cm) range hood
Również dla Whirlpool UXT2030AD: Instrukcje instalacji oraz instrukcja obsługi i konserwacji (28 strony), Instrukcje instalacji oraz instrukcja obsługi i konserwacji (32 strony)

5. Mark Hole Locations

Lift the range hood into place and insert the mounting bracket

tabs through the slots in the back of the range hood.

Hold the range hood firmly in place with one hand and

bend each mounting tab (A) upward approximately 90°.

Mark the hole at the power supply knockout (B).

Mark the 4 vent hole locations (C) on the top of the range hood.

OPTIONAL: Mark the hole in each mounting tab.

Remove the range hood and set it aside.

90˚

6. Mark and Cut Vent Opening

7" (17.8 cm) Round Vent System

Using the 7" (17.8 cm) round vent mounting plate, draw

■

the vent opening outline on the underside of the cabinet:

Place the vent mounting plate on the bottom of the

cabinet. Position the edge of the plate with the widest

distance (A) between the hole and edge of the mounting

plate against the wall. Position the side edges of the

mounting plate between the dots marked previously.

IMPORTANT: The widest edge (A) of the vent

mounting plate must be positioned against the wall.

Trace the 7" (17.8 cm) vent opening (solid line)

on the cabinet bottom.

Using a jigsaw or keyhole saw, cut the vent opening

■

1" (2.5 cm) larger than the 7" (17.8 cm) hole traced

(dashed line).

7. Drill Electrical Opening

Using a 1

" (3 cm) drill bit, drill the hole in the dot

marked previously at the electrical strain relief.

OPTIONAL: Using a

" (3 mm) drill bit, drill pilot holes

for the dots marked previously at each mounting tab

at an approximate 45° angle in an upward direction.

(2.5 cm)