Whirlpool UXT4030AYT0 Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny Whirlpool UXT4030AYT0. Whirlpool UXT4030AYT0 24 stron. 30" (76.2 cm) and 36" (91.4 cm) range hood installation instructions
Drukuj stronę
RANGE HOOD CARE
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter
before operating hood.
Exterior Surfaces:
IMPORTANT:
Do not use soap-filled
scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use cleaners that
contain chlorine.
Cleaning
Method:
•
Rub in direction of grain to avoid scratching
or damaging the
surface.
For stainless steal models, Stainless Steel Cleaner and Polish
Part Number 31462A (not included): See "Assistance
or
Service" section to order.
•
Liquid detergent or all-purpose
cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
•
Glass cleaner to remove fingerprints.
Charcoal
Filter
The charcoal filter is not washable. It should last up to 6 months
with normal use.
Replace the old charcoal filter with a new charcoal filter. For
information
on ordering, see the "Accessories"
section.
To replace filter:
1. Remove screw from the filter retainer.
2. Turn the filter retainer to release filter.
3. Reinstall the filter by placing the back edge in the channel at
rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.
4. Replace screw in the filter retainer.
Replacing
the Incandescent
Light Bulb
Turn off the range hood and allow the light bulb to cool.
1. Disconnect
power.
2. Squeeze the plastic lens cover and remove it from the hood.
B
A
A. Light bulb socket
B. Lens cover
3. Screw light bulb into socket.
4. Replace lens cover by squeezing cover and inserting tabs
into slots.
5. Reconnect power.
If new light does not operate, make sure the lamp is inserted
correctly before calling service.
A. Filter retainer