Whirlpool W10029770A Instrukcje instalacji oraz instrukcja obsługi i konserwacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcje instalacji oraz instrukcja obsługi i konserwacji dla Okap wentylacyjny Whirlpool W10029770A. Whirlpool W10029770A 28 stron. 90 cm (35 ²⁄₅") wall-mount canopy range hood
Drukuj stronę
Vent Cover Bracket Installation
Installations using telescoping upper and lower vent cover
assembly
1. Position vent cover bracket on wall about
from the ceiling.
2. Mark the hole locations.
A. Vent cover bracket
B. Mounting hole locations
C. Centerline on wall
3. Drill
" (9.5 mm) holes for wall anchors and insert anchors
flush with the wall.
Vent Cover Bracket Assembly and Installation
4. Assemble the 3 pieces of the vent cover bracket using
four 4 x 8 mm screws provided. The assembled bracket
should be sized to fit inside the upper vent cover.
D
C
A. Vent cover bracket assembly
B. Upper vent cover
C. 4 x 8 mm screws
D. Adjustable width
5. Install vent cover bracket to wall about
the ceiling with drywall anchors and 6 x 70 mm screws
supplied.
A. Vent cover bracket
B. Centerline on wall
8
" (3 mm) away
A
B
C
A
D
B
" (3 mm) away from
A
B
Non-vented (recirculating) Installation
1. Assemble the 3 parts of the deflector with two 3.5 x 9.5 mm
screws provided. The assembled deflector should be sized to
fit the width of the vent cover bracket installed earlier.
C
A. Vent cover bracket width
B. Deflector
C. 3.5 x 9.5 mm screws
2. Connect the deflector to the vent cover bracket using
four 3.5 x 9.5 mm screws provided.
B
A. Vent cover bracket
B. 3.5 x 9.5 mm screws
3. Measure length of 6" (15.2 cm) vent needed to connect the
transition to the deflector.
NOTE: Vent should fit up inside deflector a minimum of
1" (2.5 cm) minimum.
4. Install vent between the transition and the deflector.
5. Seal all connections with clamps.
A
B
A
B