AER Domino2 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt muzyczny AER Domino2. AER Domino2 11 stron.

Drukuj stronę

Domino

4. Summary of Operations

• Connecting and starting-up:

Check to ensure that mains voltage at your location

corresponds to what is permitted to operate the

DOMINO. You will find the necessary information

on the sticker at the rear side of the amp under

"voltage". Before switching on the amp, "Master" and

"Return" controls should be turned to zero position

(as far left as they may go) and all other controls to

middle position. Then make all necessary cable

connections (mains, instruments, microphone and

link). Now you can turn on your DOMINO with the

power switch on the rear of the amp. The green

power indicator shows that the amp is working.

• Level control

You can use the "High/Low"-switch, the "Line/Mic"-

switch and the "Gain"-control to adjust the various

pick-up systems and signal sources to the DOMINO.

The "Clip"-indicator shows that the input signal is

too high. To ensure distortion-free reproduction you

should then reduce "Gain"-control or "Volume"-

control on your signal source.

Clipping can already accure at very low or even

maximum gain depending on the output of your

source. Pleace verify: set the master control to zero

position. Play at a high dynamic level and increase

the gain level to the point the clip indicator starts

to flicker. With that you can be sure that youre source

is able to fully address the inputstage. Reduce the

gain a little bit to generate additional dynamic head-

room and then use the master control to adjust the

final overall volume.

Temporary flickering gives no cause of concern. But

you should pay attention not to get above this level.

Please consider the Domino has four channels. For

individual input gains add up and may distored the

-6-

signal incoming the effect unit. This distortion is not

monitored by the clipping indicator. It is only audible.

In any case of audible distortion reduce the gains.

You can mute the channels either by mute switches

per channel or via footswitch.

• Tone controls

The three band tone controls of your DOMINO are

designed to fulfill the special requirements of acoustic

instruments as well as general demands of other

sources. The "Colour"- switches activate a "mid-cut

treble-boost"-filter, which is particularly appropriate

for fingerstyle techniques.

• Effects

The DOMINO has an integrated (internal) digital 32

bit AER-effect processor, providing you with

16 presets (reverb, delay, chorus – see Appd. 1) to

be selected by the "Effect Select"-switch. The

"Return"- control determines the intensity of the

total effect (as far left as possible = no effect).

The individual effect sends adjust the amount of

effect per channel.

Furthermore a supplementary effect device can be

connected (external effect). For this purpose, use

the sockets "Send" and "Return" on the rear of the

DOMINO ("Send" to the input, "Return" to the out-

put of the external effect). The intensity will then

be determined by the Effect 2-return.

You can connect a stereo (double) footswitch either

to footswitch effect or footswitch 1,2,3,4 to switch

the effects on/off (internal and external) or mute

the channels.