Fireside Furnishings Kenwood Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria do kominków Fireside Furnishings Kenwood. Fireside Furnishings Kenwood 6 stron. Wall cabinet
Drukuj stronęAssembly steps
1.
Attach the the breast board (b) to the left leg (c) and right leg
(d) by inserting dowels and cam pin into matching holes on ends
of breastboard. Before inserting, make sure that the arrow on
the cam in the breast board points toward the edge of board.
Push the breast board until dowels are fully inserted into the
legs and there is no gap between leg and breast board. Using a
philips screwdriver, turn the cams in breastboard clock-wise
until snug. Do not rely on the cam to pull the two together. Do
not over-tighten, as too much torque can break the cam.
3.
Attach marble cleats (e)(f) to the back of breast board and legs
using twelve #8 2.0" drywall screws. Attach horizontal marble
cleat (g) first, centered. Refer to fireplace manufacturer's installa-
tion instruction to determine the minimum clearance from the
firebox to combustible material. Then attach two vertical marble
cleats (h) to legs, parallel with legs and leaving 3/4" minimum
clearance from floor. Recommended dimensions shown below.
www.fireplaces.com
2.
Screw 8 #8 1-1/2" drywall screws (m) through the breast board
to the left and right legs.
4.
If you are not using optional base, go to the step 6.
Install optional base. Secure the base using construction adhe-
sive or finishing nails. If using finishing nails, use a stud finder or
other method, locate at least two studs in the wall above the base.
Push the base tightly against the wall,
45 degree angle down through the top, as shown in above. Using
16d finish nails, nail the base to the wall. Use a nail set to set the
nail head below surface of the top.
3
drill 3/32" pilot holes at a
KENWOOD-WALL-CAB
REV. 1
06.17.2009