ABB RDCO-04 Skrócona instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Jednostka sterująca ABB RDCO-04. ABB RDCO-04 3 stron. Ddcs communication option modules

Drukuj stronę

Installation Procedure

Access the optional module slots on the drive. Whenever

necessary, refer to the Hardware Manual of the drive for

instructions on removing any covers.

Insert the module carefully into the slot marked with

"DDCS" (BCU control unit slot 4) on the control board

until the retaining clips lock the module into position.

Fasten the screws included in the package. Note that

correct installation of the screws is essential for fulfilling

the EMC requirements and for proper operation of the

module.

Lead the fiber optic cables from the external device to the

appropriate channel(s) of the RDCO. Inside the drive,

route the cables as shown in its Hardware Manual. Make

sure the cables are not kinked or laid against sharp

edges. Observe colour coding so that transmitters are

connected to receivers and vice versa. In case multiple

devices are to be connected to one channel, they must

be connected in a ring.

Technical data

Module types: RDCO-01(C), RDCO-02(C), RDCO-03(C),

RDCO-04(C)

Degree of protection: IP 20

Ambient conditions: The applicable ambient conditions

specified for the drive in its Hardware Manual are in effect.

www.abb.com/drives

www.abb.com/drivespartners

Connectors:

•

20-pin pinheader

•

4 transmitter/receiver connector pairs for fiber optic cable.

Type: Agilent Technologies Versatile Link. Communication

speed: 1, 2 or 4 Mbit/s

Operating voltage: +5 V DC ±10%, supplied by the control

unit of the drive.

Current consumption: 200 mA max.

Electromagnetic immunity: IEC 1000-4-2 (limits: industrial,

second environment); IEC 1000-4-3; IEC 1000-4-4;

IEC 1000-4-6

Electromagnetic emissions: EN 50081-2; CISPR 11

Dimensions (mm):