Firetide HotPoint 5100 Instrukcja instalacji sprzętu - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji sprzętu dla Bezprzewodowy punkt dostępowy Firetide HotPoint 5100. Firetide HotPoint 5100 19 stron.
Również dla Firetide HotPoint 5100: Podręcznik (2 strony)
Drukuj stronę
Using Power over Ethernet
A Power over Ethernet (PoE) injector is available as an optional accessory.
The PoE injector lets a HotPort 7020 mesh node supply power to a HotPoint 5100
access point. It also lets you use a computer to supply power to an access point so
you can configure it in the field.
To connect the PoE injector to a computer or mesh node:
• Attach one Ethernet cable from the access point to the OUT port on the PoE
injector.
• Attach another Ethernet cable from the computer to the IN port on the PoE
injector.
• (Optional) Attach the PoE injector to a power source.
Connecting a computer to a new access point
You need to change the TCP/IP4 settings on your computer so that you can
communicate with the access point. The first time you connect to the access
point, you need to change the TCP/IP4 setting on your computer.
Note: If you are using PoE, connect your computer directly to the IN port on the
POE injector.
192.168.224.160 is the default IP address of the access point.
1. Attach the Ethernet cable from the Ethernet port on the access point to an
Ethernet port on the administrator computer.
2. Supply power to the access point. If you use a PoE injector (optional
accessory), the access point receives power from your computer.
The access point boots in 1.5 (when connected to a direct power source) to 2
minutes (when receiving power from the PoE injector). The power LED glows
steady.
HotPoint 5100 access point preparation
HotPoint 5100 Access Point Hardware Installation Guide 5