Bad Dog Designs Nixie Clocks 6 TUBE NIXIE CLOCK Jak działać
Przeglądaj online lub pobierz pdf Jak działać dla Zegar Bad Dog Designs Nixie Clocks 6 TUBE NIXIE CLOCK. Bad Dog Designs Nixie Clocks 6 TUBE NIXIE CLOCK 4 stron.
Drukuj stronęHOW TO OPERA TE YOUR
6 TUBE NIXIE CLOCK
There are four buttons that have the following functions:
SET: Exit tube test routine on cold power-up; Show date; Set: time, date; Enter configuration menu;
ADJ: Adjust: time, date, alarm time, configuration parameters;
ALARM: Set alarm time; snooze; cancel snooze/alarm;
DST: Toggle between DST and Standard time (+/- 1 Hour); Enter colour / Led setup menu.
Setting the Time and Date:
From time display mode, press and hold 'SET' button for 2 seconds until the seconds digits are highlighted.
Press the 'ADJ' button to reset seconds to zero. Briefly Press 'SET' again and the minutes will be highlighted
Press the 'ADJ' button to set the minutes. Briefly Press 'SET' again and the hours will be highlighted. Press
the 'ADJ' button to set the hours. Proceed in this fashion to set the calendar: Year, Month and Day. Finally,
briefly Press 'SET' again to revert to normal clock operation.
Showing Date:
From time display mode, briefly press 'SET' button. Date will be shown for 5 seconds, then revert to time
display.
Manual RFT Call:
In DCF / MSF modes, pressing 'ADJ' briefly during time display will initiate a manual time seek for maximum
6 minutes, or until a valid time frame is received.
Setting Alarm:
Press the 'ALARM' Button. The seconds digits show the on / o status of the alarm: 00 or 01 (o or on). Set
on / o status, then minutes followed by hours by using the 'ALARM' and 'ADJ' buttons. When set, the
alarm LED will also light (if fitted on the clock)
Cancelling Alarm:
Press 'ALARM' briefly to cancel alarm and enter snooze mode, or a longer press until the clock bleeps, to
cancel snooze. Alarm remains set for the next day.
Rapid Daylight Savings Time Adjustment:
Press 'DST' briefly to toggle between DST and standard time. The indicator (where fitted) shows whether
DST mode is active or not. If the time has been synchronised from DCF or MSF sources, this light will be set
or cleared automatically. It can still be manually overridden, however the system will re-set the DST status
again at the next valid time sync.
Note, the GPS time date does not contain any DST information, so the DST status will need to be set
manually in GPS Sync mode, as well as manual time-set mode.