AlcoMate AL6000 Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt testowy AlcoMate AL6000. AlcoMate AL6000 4 stron.

General Information about DUI/DWI

The legal limit for intoxication (DUI/DWI) is 0.08% BAC across most of the USA.

According to the American Medical Association (AMA), a BAC of 0.05% is

enough to impair the ability to drive. You should never operate a motor vehicle

when you are impaired by the consumption of alcohol, drugs or lack of proper

rest.

Warnings

a. Wait at least 20 minutes after eating or drinking before testing. Alcohol

remaining in the mouth, or even excess saliva, may interfere with testing.

This includes alcohol-based mouthwash or similar products.

b. Avoid testing in high wind or enclosed spaces. Poor ventilation may also

lengthen the time required for warm up between tests.

c. Do not blow smoke, saliva or other contaminants into the mouthpiece, as the

sensor may become damaged.

d. Do NOT use the AlcoMate Prestige as a tool to drink and drive.

e. Keep out of extreme temperatures and out of the reach of children.

To maintain accuracy, we recommend replacing the alcohol sensor module

inside the AlcoMate Prestige every 200 tests or at least once a year,

whichever comes first. Large numbers of "high positive" (high alcohol)

readings may require replacing the module much sooner than normally

expected.

g. WARNING DISPLAY "Flo": If you see "Flo" in the display, the breath

sample was not long enough for measurement. Please try again and make

sure the breath is strong and steady during sampling. As soon as you start

blowing into the device, you will hear a long beep indicating how long you

should blow.

h. WARNING DISPLAY "SEn": If you see "SEn" in the display, there is a

general sensor module error. One reason for this error is if the new

replacement sensor module is a different COLOR than the original. You can

ONLY use sensor modules with the proper (matching) color. If this is not the

case, you may return the device for technical service.

WARNING DISPLAY "Bat": If you see "Bat" in the display, the battery power

is low. Please replace the batteries.

Remove the battery cover at the bottom of the unit and

replace the old batteries with two new 1.5V "AA" batteries.

Make sure to properly align the batteries by looking at the +/-

marks.