Clarion 2/1 Channel Power Amplifier DPX1000.2 Instrukcja obsługi i instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Wzmacniacz Clarion 2/1 Channel Power Amplifier DPX1000.2. Clarion 2/1 Channel Power Amplifier DPX1000.2 16 stron. Digital 2/1 channel power system amplifier
Również dla Clarion 2/1 Channel Power Amplifier DPX1000.2: Podręcznik (8 strony)
Drukuj stronę
DPX1000.2 Power System Amplifier
INPUT CONNECTIONS AND AUDIO CONTROLS
The front panel of the DPX1000.2 contains connections for RCA Inputs,
Speaker Level Inputs and Audio Controls as shown below.
The RCA Input Connections are gold-plated RCA Jacks and are labeled as
RIGHT and LEFT.
1
1 Speaker Level Inputs
2 RCA Input Jacks
3 Remote Sub level Connector
4 Gain Control
5 Subsonic Filter Selection Switch
•
that allows adjustment from a remote location .
•
eliminates unwanted frequencies from 24Hz and below.
•
amplifier. The amplifier's range, 250mV to 2.5V for RCA inputs or 500mV to
5V for speaker level inputs, can accommodate input levels from virtually any
brand of source unit.
•
frequency band) Bass Boost circuit. It acts much like an equalizer, with
adjustable gain (from 0 to +15dB) fixed at 45Hz. Use this feature to tune low-
frequency audio response to compensate for a less than ideal subwoofer
enclosure design. The added boost produces rich, full bass tones that are
normally difficult to reproduce in the car audio environment. Note: If Bass
Boost is undesired, set Bass Boost to 0dB.
•
adjustable between 55Hz and 550Hz for a wide range of crossover points. Use
4
2
3
4
- This port is for the supplied remote gain control
- This switch will activate the Subsonic Filter Circuit which
- This allows you to set the nominal operating level of the
- The amplifier also features a "high-Q" (i.e. narrow
5
6
7
8
9
6 Bass Boost Control
7 Freq (Hz) Selection Control
8 X-Over Slope Select Switch
9 Output Select Switch
0 Input Select Switch
- The crossover frequency is fully
10