Acond Hydromodul Instrukcja instalacji - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Podgrzewacz wody Acond Hydromodul. Acond Hydromodul 17 stron.

Be careful, hot water may flow out of the valve.

9.4 Disconnect from the mains

First, use the AcondTherm regulation to switch off the device and then disconnect the device

from the main by switching off the circuit breaker in the main home switchboard.

Clean the hydromodule with products designed for stainless materials.

Do not use any types of sprays around the hydromodulu. This is especially true

for

• Solvents

• Cleaning products containing chlorine

• Colors

• Glues

The E-heater has a built-in safety thermostat that disconnects the heating rod from the power

supply if the heating water temperature is too high. If this happens, it is necessary to manually

reset the thermostat.

To reset the thermostat

1. Remove the Hydormodule covers, see chapter 7.5.

2. Diagnose if the thermostat is disconnected

a. In the AcondTherm regulation, manually start the heating rod by clicking on the

icon.

b. Check whether the contactor of the heating rod (marked KM1) displays contactor

(red color). If green is visible, the contactor has not switched on and the

thermostat needs to be reset.

3. Switch off the circuit breaker in the home main switchboard.

4. Reset the thermostat is done by pressing the button, see the following picture.

Installation manual

Hydromodul