Xerox 4150xf - WorkCentre B/W Laser Podręcznik dla początkujących - Strona 19

Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Wszystko w jednej drukarce Xerox 4150xf - WorkCentre B/W Laser. Xerox 4150xf - WorkCentre B/W Laser 38 stron. Network scanning - wia configuration
Również dla Xerox 4150xf - WorkCentre B/W Laser: Broszura i specyfikacje (4 strony), Skrócona instrukcja obsługi (1 strony), Wymiana wkładów (1 strony), Instrukcja instalacji (40 strony), Instrukcja instalacji modułu (1 strony), Instrukcja instalacji sprzętu (1 strony), Instrukcja instalacji modułu tacki (1 strony), Instrukcja instalacji modułu (1 strony), Instrukcja instalacji (6 strony), Podręcznik (9 strony)

Installing Option Kits

This section provides instructions on how to install and configure optional features:

• Network Scanning

• Hard Disk Overwrite

• Server Fax

• Network Accounting

NOTE:

For instructions on installing and configuring Server Fax and Network Accounting,

refer to the System Administration CD.

Installing Option Kits

All the Option Kits are installed in the same way. Each kit will contain a Feature Enablement

Key and instructions.

With the WorkCentre switched on, insert

the Feature Enablement Key into the Card

Reader slot just above the On/Off switch on

the left hand side of the machine.

When the feature is successfully installed a

pop-up message will tell you that the

feature is configured and ask you to

remove the Feature Enablement Key.

Network Scanning

Network Scanning is an optional feature, available for the WorkCentre 4150s, 4150x and

4150xf, and can be purchased from your Xerox Sales Representative.

Network Scanning enables you to convert your hard copy documents to electronic files and

retrieve them from a server or workstation on the network.

There are two ways to configure Network Scanning:

• Use Internet Services, the WorkCentre's embedded web server, to set up the

Network Scanning feature. Installation and setup of this feature is described below.

• FreeFlow™ SMARTsend™ is an optional application that will scan to a variety of

destinations. Installation and setup of this feature is described in the FreeFlow™

SMARTsend™ System Administrators CD that comes with the application.

NOTE:

Scanning services should be enabled on your network before you enable the

Network Scanning option.

Install Internet Services Network Scanning

Configure the option. Refer to Installing Option Kits on page 15

Create a Network Scanning Repository

At your PC, open your web browser and enter the Host Name or IP address of the

WorkCentre.

Select Properties > Services > Network Scanning > File Repository Setup.

getting started guide

Card Reader

slot