Xerox 460 Podręcznik szybkiej instalacji - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik szybkiej instalacji dla Wszystko w jednej drukarce Xerox 460. Xerox 460 38 stron. Macintosh driver information
Również dla Xerox 460: Podręcznik informacyjny (13 strony)
Drukuj stronę
DHCP / BOOTP Dynamic IP Address Assignment Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and follow
the instructions.
NOTE: By default, DHCP is enabled on the
Document Centre. This card will show you
how to disable DHCP (or enable it if it was
disabled) and set your TCP/IP information
using BOOTP.
DHCP servers vary in the information that they
return to the host computer requesting service.
Your Document Centre can retrieve the following
values from a DHCP server:
TCP/IP Address
Host Name
Subnet Mask
Gateway TCP/IP Address
Broadcast Address
Consult the documentation supplied with your
DHCP server software to verify what TCP/IP
information it is capable of supplying.
Go to the DHCP server and...
1.
Configure the DHCP server with the TCP/
IP information you want assigned to your
printer. Use the documentation supplied
with your server software for this task.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
Go to the printer and...
2.
Connect your Document Centre to the
network with the appropriate cabling.
3.
Enter the Tools pathway
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
4.
Enter the Network Setup menus.
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
5.
Enable TCP/IP printing.
a)
Press the TCP/IP Settings button.
b)
Press the Protocol and Media button.
c)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
Page 1
6.
Set the Host Name (skip steps 6a-6c if
your DHCP server supplies this
information).
a)
Press the Name/Address button.
b)
Press the Host Name button.
c)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes and exit to the
TCP/IP Settings Screen.
7.
Set the Subnet Mask and Gateway (skip
steps 7a-7b if your DHCP server supplies
this information). The Document Centre
will only accept one Gateway address
from the DHCP server.
a)
Press the Subnet and Gateway
button.
b)
Press the soft buttons on the Touch
Screen one at a time for each octet of
the Subnet Mask and enter the
numbers using the keypad. Repeat
this process for the IP Gateway
address. When finished press Save to
record the changes and exit to the
TCP/IP Settings Screen.