Xerox DC230LP Szybka instalacja - Strona 3
Przeglądaj online lub pobierz pdf Szybka instalacja dla Wszystko w jednej drukarce Xerox DC230LP. Xerox DC230LP 4 stron. Windows nt 4.0 tcp/ip
Drukuj stronę
d)
Press [
] repeatedly to delete the
current entry.
e)
Use the [ ] or [ ] key to select the
first character in the Printer Name.
f)
Press [
] to move to the next charac-
ter. Repeat this procedure to enter the
entire Printer Name.
g)
Press [Enter]. **SAVED** displays
momentarily, followed by
>
Printer Name
.
(your entry)
10.
Enable the Line Printer Daemon (LPD):
a)
Press [Escape] to move back a level
in the menu system.
>
TCP/IP -
displays.
Line Printer
b)
Press [ ] until
Daemon
displays.
Enablement
c)
Press [
].
(current entry)
Enablement
d)
Press [
].
(current entry)
Enablement
e)
Press [ ] until
Enabled
displays.
DC230LP Windows NT
f)
Press [Enter]. **SAVED** displays
momentarily, followed by
Enablement
Enabled
Note: The next menu at this level, Port Setting ,
has a fixed setting for the LPD (515) and can not
be changed.
11.
Save all settings:
a)
Press [Online].
displays.
b)
Press [Enter].
displays. The DC230LP will reboot,
save the settings entered, and print a
Configuration Report in approximately
3 minutes.
12.
Check the settings on the Configuration
>
Report against those entered to be sure
they are correct.
>
displays.
=
displays.
*
=
®
4.0 TCP/IP Quick Install
>
.
Reset Required
Press ENTER key
>
Warming Up
Please Wait . . .
Page 3 of 4
13.
At the client, install print drivers and map
the printer in the usual manner. Refer to
®
the CentreWare
manual, Getting Started
with Print and Fax Services , for additional
information.
14.
TCP/IP protocol and TCP/IP print services
must be installed on the NT Server and the
printer name must be set to [lp] (lower
case) when configuring the LPR port.
Refer to the screen sample below.
Additional information on the Windows NT
TCP/IP setup can be found in the DC230LP
System Administration Guide, Network Installa-
tion and Troubleshooting .