Aldea Domotica Termolink WiFi Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Termostat Aldea Domotica Termolink WiFi. Aldea Domotica Termolink WiFi 8 stron. Digital screen indicatingroom temperature and clock. anti-freeze setting 4 customisable programs for each day of the week. ergonomic wall mount. relay output na 5a to 250 vac power 230 vac 50 hz size 120 x 100 x 80 mm

Drukuj stronę
Termolink WiFi
ADJUSTING THE ANTI-FREEZE TEMPERATURE
OFF
MAN
AUTO
CYCLE
ON
OFF
OFF
MAN
AUTO
CYCLE
ON
OFF
PROGRAMMING THE HEAT
OFF
MAN
AUTO
CYCLE
ON
OFF
OFF
MAN
AUTO
CYCLE
ON
OFF
OFF
MAN
AUTO
CYCLE
ON
OFF
OFF
MAN
AUTO
CYCLE
ON
OFF
OFF
MAN
AUTO
CYCLE
ON
OFF
OFF
MAN
AUTO
CYCLE
ON
OFF
From the main screen, press the
is displayed.
Then press the OK button to confirm. The screen will display
PM
the minimum set point temperature. This is the temperature
AM
at which the thermostat in automatic mode would start up
the heating even though this is not planned. This is activated
so that the room temperature will not drop too low in the
event of frost.
PM
AM
Press the
right-hand corner.
Then press the
PM
screen will be displayed.
AM
The first option displayed for change is the day of the week. If you
start programming from the first day, press the
to set the first hour the heating is to be connected, in other words,
the first time period of functioning. With the
can set the connection time. Press the
PM
minutes.
AM
Once these options have been set, press the
adjust the set point temperature of the first time period of the first
day using the
PM
AM
The next time you press the
hour and minutes for the heating to switch off during that time
period of that day.
PM
AM
When you then press the
cycle for that day will be displayed.Proceed as above to adjust
the complete cycle. If you leave the cycle at zero, the device
will not take this into account and will proceed to apply the
next cycle.
PM
AM
Continue to program each of the time period cycles with each
set point temperature in the same way.If at any time you press
the
confirming all the adjustments.
PM
AM
6
button when the letter
to confirm the selection and the programming
or
buttons.
button, it will be to adjust the
button, the next programming
button, you will exit the programming screen while
Ref. AD3012
button until the
icon
P
is displayed in the upper
button again
or
buttons you
button to adjust the
button again to