Xerox 721 Uwaga dotycząca wydania - Strona 14

Przeglądaj online lub pobierz pdf Uwaga dotycząca wydania dla Akcesoria do drukarek Xerox 721. Xerox 721 23 stron. Software tools
Również dla Xerox 721: Instrukcja obsługi (11 strony), Instrukcja konfiguracji (20 strony), Uwaga dotycząca wydania (8 strony), Podręcznik szkoleniowy dla klientów (50 strony)

8 Release Notes

The following information supplements the 12.0 customer user guides.

To maximize copying of ARCH-E size prints always copy them using the preset output format

ARCH-E. When copied in synchro mode it is likely that ARCH-E documents will scan as

1220mm and will incur unneeded pauses between printing pages. The 6204 IOT will pause

between pages which are greater than ARCH-E (48 inches 1219 mm) in length for the fuser to

come all the way back to full temp even if it is in the nominal fuser temperature range.

If the user tries to upload a stamp files that contains an invalid format, or if the Accounting Mode

is set to "Enabled", no error message will be displayed. The WebPMT screen will display a

message that the file was uploaded successfully and the stamp's filename will not appear in the

"Printer Resident Stamps" list. To avoid this situation, set the Job Accounting mode to "Optional"

before uploading stamps. The WebPMT has no knowledge of the validity of any file that is sent to

the printer. File validation and error handling is done on the printer by the FreeFlow Accxes

controller. The WebPMT only reports that the file was sent to the printer successfully.

The media size "ANY" will select the best sheet size for an image to prevent clipping. If a user

specifies a media size of "ANY" and a scale factor that makes the image too large for any sheet

size and mismatch mode is set to scale, the controller will select the largest sheet size and scale

the image to fit on it.

If this is not the desired behavior, a specific sheet size can be selected, or the media mismatch

mode can be set to QUERY.

If the margins (TOP, BOTTOM, RIGHT and LEFT) are set to a non-zero value (5mm is the

default) then that amount of whitespace will be added to the image before placing it on the media

and could cause part of the image to be shifted off the page, or clipped. To correct this problem

set the margins to 0.

Certain CGM files contain rotation commands which can confuse the system when folding. If the

titleblock is not visible or the plot is bypassed and not folded, change the titleblock location to

obtain a correctly folded document.

Page 14