Clarity P-TEC S-525 Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Głośniki Clarity P-TEC S-525. Clarity P-TEC S-525 3 stron. Voice paging speaker

Drukuj stronę

4. Connect the power-tap wire to the gold (+)

terminal (See Figure 3).

5. Arrange the unused power-tap wires neatly

inside the speaker housing and tape them to

the inside of the housing.

( + ) Gold

70V Transformer

Reusable

Quick-Connect

Connector

Arrange unused wires

neatly inside speaker housing.

Figure 3. Connecting the Tap Wire

Suspended Ceiling

Note: Wrap wires around strain relief posts so

speaker wires will not pull free.

1. Lift the adjacent ceiling tile and slide it out of

the way.

2. Install the speaker by inserting the mounting

pins through the ceiling tile, and hold the

speaker in place.

3. Place the wire and washers, and speaker

mounting clips over mounting pins (so pins

slide through clips).

Gold

Spike

Use mounting holes and screws

Figure 4. Clarity P-TEC Installation

Note: Washers provide isolation from the pins if

the back of the tile is covered with metal

foil.

( - ) Silver

Black - Common

(Connected at Factory)

Power Tap Wires

Yellow

- 1/4 Watt

Yellow

Red

- 1/2 Watt

Red

Green

1 Watt

Green

White

Blue

Tap Wire

Amplifier

Red

Black

Silver

Spike

when spikes can not be used.

4. If necessary, adjust paging volume after instal-

lation. The volume control is located on the

side of the speaker. Use a small screwdriver to

turn the control.

5. Install the volume control cover found in the

accessory pack.

Note: The music volume should be adjusted at

the paging amplifier or music source.

Adjust paging before adjusting background

music.

- 1/4 Watt

Maintain Speaker Phasing

- 1/2 Watt

1 Watt

2 Watt

When using multiple speakers in a single run,

4 Watt

keep speakers in phase by connecting the

speaker wires to the same spike on each speaker

(Either wire can connect on either spike, as long

as the pattern is followed on each speaker). The

gold spike is the plus (+) terminal (See Figure 5).

To Paging

Amplifier

Gold ( + )

Figure 5. Maintaining Speaker Phasing

Handling Shielded Speaker Cable

If you are using shielded speaker cable, splice the

shield wire at the speaker location so a continu-

ous shield is maintained. When connecting a sin-

gle speaker, or the last speaker on the run, clip

the shield wire where it emerges from the outer

insulation on the speaker cable.

TECHNICAL ASSISTANCE

When calling, have a VOM and a telephone test

set available and call from the job site.

Call (540) 767-1550 for Clarity Technical Support,

or call (540) 767-1555 for Valcom 24-hour Fax-

back System or visit our websites at

http://www.clarity-com.com and www.valcom.com.

Should repairs be necessary, attach a tag to the

unit clearly stating company name, address,

phone number, contact person and the nature of

the problem. Send the unit to:

Clarity

Repair and Return Dept.

5614 Hollins Road

Roanoke, VA 24019-5056

To Next

Speaker