Xerox 721 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oprogramowanie Xerox 721. Xerox 721 11 stron. Software tools
Również dla Xerox 721: Instrukcja konfiguracji (20 strony), Uwaga dotycząca wydania (23 strony), Uwaga dotycząca wydania (8 strony), Podręcznik szkoleniowy dla klientów (50 strony)

Drukuj stronę

Safety Notes

Your stacker has been designed and tested to meet strict safety requirements. These include safety agency examination and approval, and

compliance to established environmental standards. Please read the following instructions carefully before operating the Stacker.

NOTE: Refer to Instructions as needed to ensure the continued safe operation of your stacker.

FOLLOW all warnings and instructions marked on or supplied with the product.

UNPLUG the stacker from the wall outlet before cleaning. Always

use materials supplied or approved by Xerox. Use of other materials

may result in poor performance and could create a hazardous

situation.

DO NOT use aerosol cleaners

NEVER use supplies or cleaning materials for purposes other than

what they were intended. Keep all supplies and materials out of

reach of children.

DO NOT use the stacker near water, wet locations, or outdoors.

This copier must be grounded.

THIS PRODUCT is equipped with a 3-wire grounding-type plug (i.e.,

a plug having a third grounding pin) and an additional safety device.

This plug will only fit into a grounding-type power outlet. This is a

safety feature. To avoid risk of electric shock, contact your

electrician to replace the receptacle if you are unable to insert the

plug into the outlet. Never use a ground adapter plug to connect the

copier to a power source receptacle that lacks a ground connection

terminal.

THIS STACKER should be operated from the type of power source

indicated on the marking label. If you are not sure of the type of

power available, consult your local power company.

WARNING

IF AN EXTENSION CORD is used with this stacker, ensure that the

total of the ampere ratings of the products plugged into the extension

cord does not exceed the extension cord ampere rating. Also, make

sure that the total amperage of all products plugged into the wall

outlet does not exceed the outlet protection.

DO NOT install the stacker in direct sunlight, a high humidity or dusty

environment.

DO NOT install the stacker where the floor or base is unstable. The

stacker may fall, causing personal injury and/or serious damage to

the stacker.

NEVER spill liquid of any kind on the stacker.

DO NOT allow anything to rest on the power cord. Do not locate this

stacker where people will step on the cord.

NEVER remove any covers or guards that require a tool for removal.

There are no operator-serviceable areas within these covers.

THE POWER SUPPLY CORD is the disconnect device for this

stacker. Ensure that installation is near the outlet and is easily

accessible.

NEVER attempt any function that is not specified in this User Guide

or directed by an authorized Xerox representative.