Xerox Fiery EX8002 Dodatek dla użytkownika

Przeglądaj online lub pobierz pdf Dodatek dla użytkownika dla Serwer druku Xerox Fiery EX8002. Xerox Fiery EX8002 28 stron. Powered by fiery, version 1.0 for the docucolor 8002/7002 digital press

Drukuj stronę

System

requirements

Customer User Addendum

Xerox EX8002 Print Server, Powered by Fiery®, version 1.0

for the DocuColor 8002/7002 digital press

This document contains information about Xerox EX8002 Print Server, Powered by Fiery

software version 1.0.

This document uses the term "EX8002" to refer to the Xerox EX8002 Print Server,

OTE

digital press.

This document describes the calibration and profiling features of the digital press. The in-line

spectrophotometer (ILS) on the digital press can be used to calibrate the EX8002 and can also

be used to create custom output profiles. Calibration and profiling can enhance the quality

and consistency of the color output.

The calibration and profiling features of the digital press are accessed from ColorWise Pro

Tools Calibrator. Calibrator lets you:

• Calibrate the EX8002 using an existing calibration set.

• Create a new calibration set and profile for specific print settings and paper.

To use the calibration and profiling features of the digital press, your system must have the

following:

• The EX8002 must be connected to the ILS on the digital press via a serial cable.

The serial cable is installed during the initial setup of your system. If an error occurs

during color measurement, there might be a problem with the serial cable. Contact your

authorized service representative.

• EFI Color Profiler Suite must be installed and enabled on the EX8002 (the factory default

condition).

If measurement is successful but the data is incorrect, check that Color Profiler Suite is

installed on the EX8002.

Part Number:

45087638

21 August 2009