Econoco SteamButler ST500 Podręcznik - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik dla Odkurzacz parowy Econoco SteamButler ST500. Econoco SteamButler ST500 8 stron.

Safety Reminders

• BEFORE PLUGGING IN your steamer, be sure the electrical information on the label on the bottom of the base

agrees with your power supply. This is a high wattage appliance. To avoid a circuit overload, DO NOT operate

another high wattage appliance on the same circuit at the same time.

• READ ALL INSTRUCTIONS before using your steamer.

• USE THE STEAMER ONLY for its intended use.

• TO PROTECT against the risk of electric shock, DO NOT immerse the appliance in water.

• ALWAYS turn the switch to the OFF position before plugging in or unplugging the unit.

• NEVER yank the cord from the outlet. ALWAYS grasp the plug and pull it out to disconnect.

• DO NOT allow the cord to touch hot surfaces.

• DO NOT leave the steamer unattended while it is operational.

• ALWAYS allow the appliance to cool completely for at least thirty minutes before storing.

• DO NOT operate the steamer without properly filling the reservoir.

• ALWAYS check the water level upon initial operation.

• ONLY hang the steamer hose end on the supplied hanger rod.

• DO NOT lay the hose on the ground or wind it unnecessarily.

• MOVE the appliance by grasping the hose and the hose hanging rod. Do not force the casters. If they stick for

some reason, turn the appliance OFF, then empty the reservoir and inspect the casters.

• The appliance has a very hot surface. DO NOT allow unsupervised children to use it.

• ALWAYS disconnect the appliance from the outlet BEFORE filling with or removing water. Be careful to AVOID

spilling excess water into the reservoir when removing or placing the reservoir bottle into the reservoir.

• DIFFERENT water sources contain different levels of mineral content. If the steamer begins to cut on and off

during normal use, the thermostat is indicating that the unit may have sediment inside which needs to be

cleaned out.

• ALWAYS allow the unit to cool completely before inspecting or cleaning the interior.

• ALWAYS disconnect the appliance when not in use.

• DO NOT use the appliance if it has been dropped or damaged. DO NOT disassemble the appliance. Incorrect

reassembly can cause a risk of electric shock. Send it to an authorized service center for repair.

• DO NOT operate another high wattage appliance on the same circuit.

• If an EXTENSION CORD is necessary, use a 20 Ampere Cord for 110V/ 120V appliances. Cords rated for less

amperage may overheat.

• This appliance MUST BE grounded. DO NOT alter the plug or attempt to defeat this feature.

• Be careful. Burns can occur from touching HOT METAL PARTS, HOT WATER, OR STEAM.

SAVE THESE INSTRUCTIONS!