Caley Coaches CL02/2a Instrukcje budowania - Strona 11

Przeglądaj online lub pobierz pdf Instrukcje budowania dla Zabawka Caley Coaches CL02/2a. Caley Coaches CL02/2a 12 stron. Caledonian railway classes 812 & 652 0-6-0 locomotives

Drukuj stronę

frames in place.

8.5

Fold up the rear lower steps (part 28) and the rear upper steps (part 29) such that the half etched

portion forms one leg of an "L" (half etch to inside of the fold as usual). Solder the lower steps

to the lower edge of the rear step supports (etched integrally with the footplate valance) and the

upper ones as shown below.

8.6

Bend the lower step of the centre steps (part 27) to 90

8.7

Solder the steps to the inside of the footplate valance directly (and centrally) below the etched

grab rail holes in the footplate.

8.8

Solder the reversing lever (part 34) to the correct reversing rod (part 33 for the 652, part 33B for

the 812) perpendicular to the straight section of the rod and solder in place as shown in the G.A.

drawing.

8.9

Bend up 0.45mm wire form the cab side handrails ( 2 per side) and the grab rails above the centre

steps. Solder these in place.

8.10

Check that the handrail knob hole on the smokebox front is clear and drill holes for the other

handrail knobs as shown below :-

8.11

The 3 short handrail knobs ﬁt in the 3 locations on the smokebox while the other 6 positions take

the medium knobs. Fit the knobs along the sides of the boiler and smokebox checking that their

holes line up.

8.12

Thread the remaining short handrail knob onto a length of 0.45mm wire and with this knob in

the centre of the length form the wire to the shape of the boiler/smokebox handrail shown in the

G.A. drawing. Thread the straight side portions through the other knobs, trim the sides to length

and ﬁnally solder the front knob in position. You may wish a touch of solder at each of the knobs

to secure them to the wire.

8.13

Fit the steam chest cover in place on the front footplate and the front buffer bases. The heads are

probably best left off until after painting.

8.14

Nearly there now! You now need to consider the type of brakes etc. ﬁtted to your engine. If it is

Caley Coaches

CL02/2a Building Instructions

and bend up the step edges to about 30

Page 11