Alderlea T4 Instrukcja instalacji i obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Piec na drewno Alderlea T4. Alderlea T4 20 stron. Cast iron wood stove

230611-20 ALT4

Lighting for the First Time

Curing of the Paint Finish

To achieve the best fi nish, the paint on your stove must be baked on. When burning your

stove for the fi rst 2-3 times it is very important that the room be well ventilated. Open all

windows and doors. Smoke and fumes caused by the curing process may cause discomfort

to some individuals.

WARNING: Never use chemicals or any other volatile liquid to start a fi re.

Adjust air control to maximum fi ring position (start position) and open door.

2. Place crumpled newspaper in the centre of the heater and criss-cross with several

pieces of dry kindling. Add a few small pieces of dry wood on top.

3. Ignite the paper and close the door.

4. After the fi re has established itself, open the door and add a few small logs. Close the

door.

5. Begin normal operation after a good coal base exists and wood has charred.

Set air control to a desired setting. If smoke pours down across the glass (waterfall

effect) this indicates you have shut the control down too soon or you are using too low

a setting. As every home's heating needs vary (based on insulation, windows, climate,

etc.) the proper setting can only be found by trial and error and should be noted for

future burns.

2. To refuel, adjust air control to high, and give the fi re time to brighten. Open the door

slowly, this will prevent backpuffing.

3. Use wood of different shape, diameter and length (up to 18"). Load your wood side to

side and try to place the logs so that the air can fl ow between them. Always use dry

wood.

4. Do not load fuel to a height or in such a manner that would be hazardous when opening

the door.

5. For extended or overnight burns, unsplit logs are preferred. Remember to char the wood

completely on maximum setting before adjusting air control for overnight burn.

WARNING: Always keep loading door closed when burning. This heater is not designed

for open door burning.

WARNING: No alteration or modifi cation of the combustion air control assembly is

permitted. Any tampering will void warranty and could be very hazardous.

WARNING: Do not use grates or andirons to elevate the fuel. Burn directly on the fi re

bricks. Replace broken or missing bricks. Failure to do so may create a hazardous

condition.