Alderlea T4 Instrukcja instalacji i obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Piec na drewno Alderlea T4. Alderlea T4 20 stron. Cast iron wood stove

Chimney and Connector – Residential

Connect to a listed chimney or a chimney suitable for use with solid fuel that is lined and

in good condition and meets local building codes. The chimney fl ue size should be the

same as the stove outlet for optimal performance. Reducing or increasing the fl ue size may

adversely affect stove performance. Chimney fl ue exit is to be 3 feet (1 m) above roof and

two feet (0.6 m) above highest projection within 10 feet (3 m). The installation must meet all

local codes. Do not connect this unit to a chimney fl ue serving another appliance. Minimum

system height is 15 feet (4.6 m) (measured from base of appliance).

Double-Wall Connector – Residential

•

Use a listed double-wall connector suitable for solid fuel.

•

Install all components to the chimney connector manufacturer's installation

requirements.

Single-Wall Connector – Residential

Smoke pipe must be:

•

As short and straight as possible, use six inch diameter, 24 gauge black pipe that is

clean and in new condition.

•

Secured at every joint and collar with 3 sheet metal screws.

•

Installed with the crimped or male ends pointing down. This will carry any liquid creosote

or condensation back into the stove.

•

The chimney connector shall not pass through an attic, roof space, closet or similar

concealed space, fl oor, or ceiling. Where passage through a wall, or partition of combustible

material is desired, the installation shall conform to CAN/CSA-B365, Installation Code

for Solid-Fuel-Burning Appliances and Equipment.

Installation Procedure – Residential

If a listed chimney and double-wall connector is to be connected to the stove, install all

components to the chimney manufacturer's installation requirements. (Outside combustion

air may be required, consult local building codes. See Combustion Air section on page

11.)

2. If it is desirable to use smoke pipe in conjunction with the insulated chimney,

see step 4.

3. If a roof or ceiling support is used in the installation, you will fi nd the chimney manufacturer's

complete instructions packed with the roof support.

4. To start installing smoke pipe (chimney connector), slip crimped edge of the pipe inside

the stove collar. Use holes provided in collar to secure pipe with three screws.

5. Install the remaining lengths of pipe, one on top of the other, to the fi nished height of

the chimney connector and secure to each other.

230611-20 ALT4