Alderon Industries ProbeX Series Instrukcja obsługi, konserwacji i instalacji

Przeglądaj online lub pobierz pdf Instrukcja obsługi, konserwacji i instalacji dla Przełącznik Alderon Industries ProbeX Series. Alderon Industries ProbeX Series 4 stron. Vertical pump switch

Drukuj stronę
Alderon Industries ProbeX Series Instrukcja obsługi, konserwacji i instalacji
ProbeX
Pump Switch
™
ProbeX™ Series Vertical Pump Switch
Operation, Maintenance and Installation Manual
Introduction
120VAC Model
(pump switch housing/enclosure only)
ProbeX™ Probes
(Reference, Stop/Red, and Start/Green)
Safety Guidelines
1. DISCONNECT ALL ELECTRICAL SERVICE BEFORE WORKING ON OR HANDLING THE PRODUCT.
2. DO NOT USE WITH FLAMMABLE OR EXPLOSIVE FLUIDS SUCH AS GASOLINE, FUEL OIL, KEROSENE,
ETC. DO NOT USE IN EXPLOSIVE ATMOSPHERES.
3. PROBEX™ PUMP SWITCH MUST ONLY BE USED WITH PUMPS CONTAINING INTEGRAL THERMAL
MOTOR OVERLOAD PROTECTION.
WARNING! Do not allow the ProbeX™ pump switch housing/enclosure and power cable to be submerged in ponds or other environments that can be a shock
hazard to humans or animals. The probes however, are low voltage (12VDC), and can be in the water if the ProbeX™ housing/enclosure is mounted out of the
water. For applications where a submersible pump is used, the ProbeX™ is completely waterproof and can be submerged in the same tank.
Low Voltage
Allowable to install ProbeX™ in
a tank with a Submersible Pump
QSG00118_Rev02_IOM000022B ProbeX Pump Switch | September 23, 2020 6:43 AM
Alderon Industries • PO Box 827 Hawley, MN 56549 • P: 218-483-3034 • F: 218-483-3036 • alderonind.com
Before proceeding with the installation or operation of the product, make sure
to read all instructions thoroughly, as well as complying with all Federal, State
and Local Codes, Regulations and Practices. The product must be installed by
qualified personnel familiar with all applicable local electrical and mechanical
codes. Refer to the National Electrical Code (NFPA 70). Failure to properly install
and test this product can result in personal injury or equipment malfunction.
Line Voltage
Submersible
Pump
(120VAC Bare Lead Model - full product)
MUST Install the ProbeX™ Housing/Enclosure
DO NOT Install in
the Water Reservoir
Allowable to install ONLY THE PROBES in a pond or water feature
where humans or animals can contact the water
OUTSIDE of the Reservoir
PUMP
Installation Instructions | Page 1