Alderon Industries Mini Power Post PRPT-00003 Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przyrządy pomiarowe Alderon Industries Mini Power Post PRPT-00003. Alderon Industries Mini Power Post PRPT-00003 16 stron. Pump connection center
Również dla Alderon Industries Mini Power Post PRPT-00003: Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

Alderon Industries Mini Power Post PRPT-00003 Podręcznik użytkownika

Mini Power Post™ - USER GUIDE

Installation

DISCONNECT ALL POWER SOURCES WHEN INSTALLING OR SERVICING THIS PRODUCT. FAILURE TO

TURN OFF ALL POWER SOURCES COULD RESULT IN SERIOUS INJURY OR DEATH.

Installing Post

STEP 1: INSTALL POST

Determine the location for the post in the ground near a tank.

Drill access holes for the float switch cables using the customer

supplied conduit/fittings or Alderon's riser connection kit (refer

to step 2 below).

Note: Seal all conduits to prevent moisture and gases from

entering the post per local codes.

STEP 2: INSTALLING AN ALDERON RISER CONNECTION KIT

1. Determine location for access hole on the post. Drill access hole for the correct size terminal adapter (2.0" or 2.5" depending

on model / #2). Insert terminal adapter into access hole. On the inside of the post, use the lock nut (#1) to secure the terminal

adapter in place (use PVC cement to ensure proper bonding between the terminal adapter and post per local codes).

2. Insert PVC pipe (conduit / #3) into terminal adapter using appropriate cement for bonding.

3. Determine location on the riser to insert the conduit (2.0" or 2.5" depending on model). If your riser does not have a

pre-drilled hole for the conduit, you must drill a hole in the riser to accept the conduit. Insert conduit through the riser hole,

which is now attached with the post. Seal conduit to riser hole with silicone or per local codes.

4. Run the pump power, pump float switch, and alarm float switch cables through the PVC coupler (#5). Then continue through

the conduit and to the appropriate height inside the post for wiring. Take the 3-hole rubber grommet (#4) which has slits

next to the holes and insert cables, then insert the rubber grommet into the conduit.

5. Place the PVC coupler over the end of the conduit.

6 | Alderon Industries™ - Leading Edge Control Products