Blackberry 8703e - CDMA Informacje o produkcie - Strona 17

Przeglądaj online lub pobierz pdf Informacje o produkcie dla Telefon komórkowy Blackberry 8703e - CDMA. Blackberry 8703e - CDMA 30 stron. Wireless handheld
Również dla Blackberry 8703e - CDMA: Instrukcja konfiguracji (18 strony), Podręcznik dla początkujących (42 strony), Podręcznik dla początkujących (28 strony)

inches (25 mm) from your body. If you use a body-worn accessory not supplied by RIM when

you carry the BlackBerry device, verify that the accessory does not contain metal and keep the

BlackBerry device at least 0.98 inches (25 mm) from your body when the BlackBerry device is

turned on and connected to a wireless network.

Specific absorption rate data

THIS WIRELESS DEVICE MODEL MEETS GOVERNMENT REQUIREMENTS FOR EXPOSURE TO

RADIO WAVES.

The BlackBerry® device is a radio transmitter and receiver. It is designed and manufactured not

to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal

Communications Commission (FCC) of the U.S. Government and Industry Canada of the

Canadian Government (IC). These limits are part of comprehensive guidelines and establish

permitted levels of RF energy for the general population. The guidelines are based on standards

that were developed by independent scientific organizations through periodic and thorough

evaluation of scientific studies. The standards include a substantial safety margin designed to

assure the safety of all persons, regardless of age and health.

The exposure standard for wireless devices employs a unit of measurement known as the Specific

Absorption Rate, or SAR. The SAR limit set by the FCC/IC is 1.6W/kg*. Tests for SAR are

conducted using standard operating positions specified by the FCC/IC with the device

transmitting at its highest certified power level in all tested frequency bands. Although the SAR

is determined at the highest certified power level, the actual SAR level of the device while

operating can be well below the maximum value. This is because the device is designed to

operate at multiple power levels so as to use only the power required to reach the network. In

general, the closer you are to a wireless base station antenna, the lower the power output.