Yamaha Acoustic Instrukcja instalacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Instrument muzyczny Yamaha Acoustic. Yamaha Acoustic 11 stron. Yamaha acoustic guitar-accessory: supplementary guide
Również dla Yamaha Acoustic: Instrukcja obsługi (1 strony), Podręcznik użytkownika (35 strony), Podręcznik uzupełniający (32 strony)

Drukuj stronę

Troubleshooting

The driver cannot be installed.

• Is the USB cable connected correctly?

Check the USB cable connection. (MAGICSTOMP's Owner's Manual)

Disconnect the USB cable, then connect it again.

Windows

• Is the USB function enabled on your computer?

When you connect the MAGICSTOMP to the computer for the ﬁrst time,

if the "Add New Hardware Wizard"

function on the computer may be disabled. Perform the following steps.

1 Select [Control Panel]

98/Me), or select [Control Panel] (Windows XP: Classic View)

[System]

[Hardware]

2 Make sure that no "!" or "x" marks appear at "Universal serial bus

controller" or "USB Root Hub." If you see an "!" or "x" mark, the USB

controller is disabled. For more information, refer to the owner's

manual of your computer.

• Is any unknown device registered?

If driver installation fails, the MAGICSTOMP will be marked as an

"Unknown device," and you will not be able to install the driver. Delete

the "Unknown device" by following the steps below.

1 Select [Control Panel]

98/Me), or select [Control Panel] (Windows XP: Classic View)

[System]

[Hardware]

2 Look for "Other devises" in the menu "View devices by type."

3 If you ﬁnd "Other devices," double-click it to extend the tree to look

for "Unknown device." If one appears, select it and click the [Remove]

button.

4 Remove the USB cable from the MAGICSTOMP, and make the

connection again.

5 Install the driver again. (page2)

When controlling the MAGICSTOMP from

your computer via USB, the MAGICSTOMP

does not operate correctly or no sound is

heard.

• Did you install the driver? (Windows: page2, Macintosh: page7)

• Is the USB cable connected correctly? (MAGICSTOMP's Owner's Manual)

• Is the volume turned up on the MAGICSTOMP, playback equipment, or

application?

• Is the proper port selected in the Sound Editor for MAGICSTOMP?

• Is the latest driver installed?

• Is the effect switched "OFF"? Is the MAGICSTOMP in the Tuner Mode,

Store Mode, or Name Edit Mode? Make sure the MAGICSTOMP is in its

normal operating mode (select a patch and switch the effect "ON").

Cannot suspend or resume the computer

correctly.

• If you are using Windows 2000, you may not be able to suspend/resume

normally, depending on the particular environment (USB Host Controller,

etc.). Even so, simply disconnecting and connecting the USB cable will allow

you to use the MAGICSTOMP functions again.

(page2,

4) does not appear, the USB

[System]

[Device Manager] (for Windows

[Device Manager] (for Windows 2000/XP).

[System]

[Device Manager] (for Windows

[Device Manager] (for Windows 2000/XP).

How can I delete or re-install the driver?

Windows Me/98

1 When the MAGICSTOMP is recognized correctly, double-click

"System" in the Control Panel to open the System window.

2 Double-click the "Device Manager" tab, select "YAMAHA USB

MIDI Driver" and delete it.

3 Use the MS-DOS prompt or Explorer to delete the following three

ﬁles.

To delete the ﬁles below using Explorer, select "Folder Options"

from the Tool (View) menu, and select "Show all ﬁles (and

folders)."

• \WINDOWS\INF\OTHER\YAMAHAUB99.INF

• \WINDOWS\SYSTEM\Xgusb.drv

• \WINDOWS\SYSTEM\Ymidusb.sys

4 Disconnect the USB cable.

5 Restart the computer.

6 Re-install the driver. (page2)

Macintosh

1 Delete the ﬁles in the following locations:

• System Folder | Control Panels | YAMAHA USB MIDI Patch

• System Folder | Extensions | USB YAMAHA MIDI Driver

• System Folder | OMS Folder | YAMAHA USB MIDI OMS Driver

2 Restart the computer.

3 Install the driver (page7) and set up OMS (page9).

SOFTWARE for MAGICSTOMP

Installation Guide