Yamaha Clavinova CLP-725 Instrukcja obsługi - Strona 31
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Instrument muzyczny Yamaha Clavinova CLP-725. Yamaha Clavinova CLP-725 40 stron.
Drukuj stronę
Keyboard Stand Assembly
CAUTION
• Assemble the unit on a hard and flat floor with ample space.
• Be careful not to confuse parts, and be sure to install all
parts in the correct orientation. Please assemble the unit in
accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use only the included screws of the specified
sizes. Do not use any other screws. Use of incorrect screws
can cause damage or malfunction of the product.
• Be sure to tighten all screws upon completing assembly of
the unit.
• To disassemble the unit, reverse the assembly sequence
given below.
Have a Phillips-head (+) screwdriver of the appropriate size
ready.
Remove all parts from the package and make sure you
have all of the items.
Foamed styrol pads
Remove foamed styrol pads from the package, position them on
the floor, then place A on top of them. Position the pads so that
they will not hide the connectors on the bottom of A.
Bundled pedal
cord inside
Cord holder
6 x 20 mm long screws x 4
4 x 12 mm thin screws x 2
4 x 20 mm tapping screws x 4
6 x 16 mm short screws x 6
4 x 10 mm thin screws x 2
Caps x 4
Power cord x 1
AC adaptor x 1
The power cord and adaptor
may not be included, or may
look different from the illustration
above, depending on your
particular area. Please check
with your Yamaha dealer.
Headphone hanger x 1
1.
Attach (finger-tighten) C to D and
E.
1-1
1-1
Untie and straighten out the bundled pedal
cord.
1-2
Align D and E with each end of C.
1-3
Attach D and E to C by finger-tightening
the long screws (6 x 20 mm).
2.
Attach B.
2-2
2-3
2-2
2-1
Align the screw holes on the upper side of B
with the bracket holes on D and E, then
attach the upper corners of B to D and E by
finger-tightening two thin screws (4 x 12
mm).
2-2
While pushing the lower part of D and E
from outside, secure the bottom ends of B
using two tapping screws (4 x 20 mm).
1-3
2-1
2-2
31
CLP-725 Owner's Manual