Yamaha Silent Violin SV250 Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Instrument muzyczny Yamaha Silent Violin SV250. Yamaha Silent Violin SV250 19 stron. Owner's manual
Również dla Yamaha Silent Violin SV250: Instrukcja obsługi (18 strony)
Drukuj stronę
The SV250/255 can operate on power supplied from three different power
sources; battery power, AC power, or phantom power supplied by an external
source via the XLR cable. Always make sure that the power is switched OFF
on the external audio device, or its volume is set to "0" before switching the in-
strument's power ON.
■ Using Batteries
1
Open the battery compartment cover on the
backside of the control box.
2
Insert the two batteries supplied (SUM-3 (AA)
size). Take careful note of the polarity markings
as shown in the illustration above, and insert the
batteries.
3
Replace the battery compartment cover.
* For customers in the Netherlands
Bij dit produkt zijn batterijen geleverd.
Wanneer deze leeg zijn, moet u ze niet
weggooien maar inleveren als KCA.
About the Battery Warning Indicator (LED)
The Battery Warning Indicator located to the right of the instru-
ment jack on the control box, is usually off during normal op-
eration however, it will change from blinking to continuously lit
as battery power depletes. When the indicator starts blinking,
follow the cautions below and change the batteries as soon as
possible.
• Always follow the +/– signs when inserting the batteries. Improper insertion may result in fi re.
• Always replace worn batteries with a complete set of new batteries. Never mix new and old batteries.
Do not mix different types of batteries (alkaline and manganese, or batteries from different manufac-
turers, or different types by the same manufacturer). Doing so may result in fi re.
• To prevent possible damage to the unit due to battery leakage and unnecessary power drain, remove
the batteries from the unit when it is not going to be used for an extended period of time.
• The supplied battery is for demonstration purposes.
The warning indicator blinks once when connecting a cable to the jack if the batteries have an ad-
equate charge or the power adaptor is operating properly. (When operating on phantom power alone,
the light will not fl ash when connecting a cable due to the control box design.)
10
Power Supply
Battery compartment cover
SUM-3 (AA)
size battery x2
Battery Indicator