Yamaha YDP-213 Instrukcja obsługi - Strona 34

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Instrument muzyczny Yamaha YDP-213. Yamaha YDP-213 48 stron. Yamaha digital piano owner's manual
Również dla Yamaha YDP-213: Instrukcja obsługi (48 strony)

Drukuj stronę

Keyboard Stand Assembly

CAUTION

• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-

dance with the sequence given below.

• Assembly should be carried out by at least two persons.

• Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Do

not use any other screws. Use of incorrect screws can cause damage or malfunction of the product.

• Be sure to tighten up all screws upon completing assembly of each unit.

• To disassemble, reverse the assembly sequence given below.

Have a Phillips-head (+) screwdriver ready

Remove all parts from the package and make sure you have all of the items.

Bundled pedal

cord inside

Assembly Parts

6 × 20 mm long screws ×4 1

6 × 16 mm short screws ×4 2

4 × 12 mm thin screws ×2 3

Keyboard Stand Assembly

YDP-131/YDP-213

AC power adaptor

4 × 20 mm tapping screws ×4 1

Cord holders × 2

Attach (ﬁnger-tighten) C to D and E.

1-1 Untie and straighten out the bundled pedal

cord. Don't discard the vinyl tie. You will

need it later in step 6.

1-2 Align D and E with each end of C.

1-3 Attach D and E to C by ﬁnger-tightening the

long screws 1 (6 × 20mm).

1-2

1-3

Attach B.

Depending on the model of digital piano you

purchased, the surface color of one side of B may

be different from the other side. In this case, posi-

tion B so that the side of the surface color similar

to D and E faces the player.

2-1 Place the lower side of B on each foot of D

and E, then attach the upper side to D and E.

2-2 Attach the top of B to D and E by ﬁnger-

tightening the thin screws 3 (4 × 12mm).

2-3 While pushing the lower part of D and E

from outside, secure the bottom ends of B

using two tapping screws 4 (4 × 20mm).

2-4 Insert the other two tapping screws 4 (4 ×

20mm) into the other two screw holes to

secure B.

1-1