Yamaha HTR-5130 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Yamaha HTR-5130. Yamaha HTR-5130 42 stron. Natural sound av receiver
Drukuj stronę
CONNECTIONS WITH OTHER COMPONENTS
Never plug in this unit and other components until all connections are completed.
When making connections between this unit and other components, be sure all connections are made correctly; that is to say L (left)
to L, R (right) to R, "+" to "+" and "–" to "–". Also, refer to the owner's manual for each component to be connected to this unit.
* If you have YAMAHA components numbered as 1, 3, 4, etc. on the rear panel, connections can be made easily by connecting
the output (or input) terminals of each component to the same-numbered terminals on this unit.
Turntable
*1
75 UNBAL.
FM
ANT
GND
AM
*3
ANT
PHONO
MAIN
LEVEL
50kHz
/ 9kHz
100kHz
/10kHz
-10dB 0dB
FM / AM
FREQUENCY
STEP
HTR-5130RDS
only
CD player
*1 Ground (GND) terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
*2 Voltage Selector <China and General models only>
The voltage selector on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the
AC power supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
*3 MAIN LEVEL Switch
Normally set to "0 dB". If desired, you can decrease the
output level of the MAIN SPEAKERS terminals by 10 dB by
setting this switch to "–10 dB".
8
CONNECTIONS
Monitor TV
6CH DISCRETE INPUT
MAIN
CENTER
SURROUND
L
L
R
R
SUB
WOOFER
GND
VIDEO SIGNAL
MONITOR
DVD/LD
TV/DBS
OUT
IN
AUDIO SIGNAL
CD
TAPE/MD
DVD/LD TV/DBS
IN
IN
OUT
(PLAY)
(REC)
1
3
4
Tape deck,
MD recorder, etc.
HTR-5130RDS only
TV/Satellite tuner
A
B
VCR
OUT
REAR
R
(SURROUND)
VCR
OUT
LD player,
DVD player, etc.
*4 AC OUTLETS (SWITCHED)
<Europe, Canada, U.S.A., China and General models>
..................................................... 2 SWITCHED OUTLETS
<U.K. and Australia models> .......... 1 SWITCHED OUTLET
Use these to connect the power cords from your
components to this unit.
The power to the SWITCHED AC OUTLETS is controlled
by this unit's STANDBY/ON switch or the provided remote
control transmitter's POWER
supply power to any component whenever this unit is
turned on.
The maximum power (total power consumption of
components) that can be connected to the SWITCHED AC
OUTLETS is 100 watts.
Video cassette recorder
VOLTAGE SELECTOR
<General model>
*4
AC OUTLETS
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN
A OR B: 4 MIN. /SPEAKER
A B: 8 MIN. /SPEAKER
CENTER
: 6 MIN. /SPEAKER
REAR
: 6 MIN. /SPEAKER
MAIN
A OR B: 8 MIN. /SPEAKER
A B:16 MIN. /SPEAKER
CENTER
: 8 MIN. /SPEAKER
REAR
: 8 MIN. /SPEAKER
I00W MAX. TOTAL
SWITCHED
/I key. These outlets will
*2
To AC outlet