Yamaha HTR-5280 - AV Receiver - 5.1 Channel Instrukcja serwisowa - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Odbiornik Yamaha HTR-5280 - AV Receiver - 5.1 Channel. Yamaha HTR-5280 - AV Receiver - 5.1 Channel 46 stron.

Drukuj stronę
RX-V800/RX-V800RDS/HTR-5280

TO SERVICE PERSONNEL

1. Critical Components Information
Components having special characteristics are marked s
and must be replaced with parts having specifications equal
to those originally installed.
2. Leakage Current Measurement (For 120V Models Only)
When service has been completed, it is imperative to verify
that all exposed conductive surfaces are properly insulated
from supply circuits.
Meter impedance should be equivalent to 1500 ohm shunted
by 0.15µF.
Leakage current must not exceed 0.5mA.
Be sure to test for leakage with the AC plug in both polarities.
WARNING: CHEMICAL CONTENT NOTICE!
The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and /or plastic
(where applicable) components may also contain traces of chemicals found by the California Health and Welfare Agency
(and possibly other entities) to cause cancer and/or birth defects or other reproductive harm.
DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REA-
SON WHATSOEVER!
Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or expose
eyes to solder/flux vapor!
If you come in contact with solder or components located inside the enclosure of this product, wash your hands before
handling food.

IMPEDANCE SELECTOR

1
WALL
OUTLET
WARNING
TO REDUCE THE RISK
OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
ATTENTION
RISQUE DE CHOC
ELECTRIQUE NE PAS OUVRIR.
AC OUTLETS
THIS DEVICE COMPLIES WITH PART 15 OF
THE FCC RULES. OPERATIONIS SUBJECT TO
SWITCHED
THE CONDITION THAT THIS DEVICE DOES
I20V
60Hz
NOT CAUSE HARMFUL INTERFERENCE.
I00W MAX. TOTAL
US
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN A OR B
4
MIN.
SPEAKER
MAIN A OR B
8
MIN.
SPEAKER
A
B
8
MIN.
SPEAKER
A
B
I6
MIN.
SPEAKER
CENTER
6
MIN.
SPEAKER
CENTER
8
MIN.
SPEAKER
REAR
6
MIN.
SPEAKER
REAR
8
MIN.
SPEAKER
MANUFACTURED UNDER LICENSE FROM DIGITAL THEATER SYSTEMS, INC. US PAT.
NO.5,45I,942 AND OTHER WORLD-WIDE PATENTS ISSUED AND PENDING. "DTS",
"DTS DIGITAL SURROUND", ARE TRADEMARKS OF DIGITALTHEATER SYSTEMS, INC.
COPYRIGHT 1998 DIGITAL THEATER SYATEMS, INC, ALL RIGHTS RESERVED.
IMPEDANCE SELECTOR
WARNING:
Do not change the IMPEDANCE SELECTOR
switch setting while the power to this unit is
on, otherwise this unit may be damaged.
AC LEAKAGE
EQUIPMENT
TESTER OR
UNDER TEST
EQUIVALENT
INSULATING
TABLE