Yamaha Piano Craft RX-E600 Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Yamaha Piano Craft RX-E600. Yamaha Piano Craft RX-E600 26 stron. Yamaha rx-e600: owners manual
Również dla Yamaha Piano Craft RX-E600: Instrukcja obsługi (23 strony)
Drukuj stronęRemote control
This remote control controls a whole system: not only
RX-E600 but also DVD-E600. Moreover, a cassette deck
(KX-E300) and MD recorder (MDX-E300) that level up
your system can be operated by it. Operating buttons for
each unit are explained on the pages below:
Receiver, RX-E600:
DVD player, DVD-E600:
Cassette deck, KX-E300:
MD recorder, MDX-E300:
Battery installation
1
3
1
Remove the battery compartment cover.
2
Insert batteries into the battery compartment.
3
Replace the battery compartment cover.
Battery replacement
If you find that the remote control must be used closer to
the main unit than usual, the batteries are weak. Replace
batteries with new ones.
Notes
• Use only AA, R6, UM-3 batteries for replacement.
• Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
• Remove the batteries if the remote control will not be used for
an extended period of time.
• If batteries leak, dispose of them immediately. Avoid touching
the leaked material or letting it come in contact with clothing,
etc. Clean the battery compartment thoroughly before
installing new batteries.
0104CRXE400(M).03-08.E
GETTING STARTED
@P.8
@P.18
@P.23
@P.23
2
3
Remote control operation range
NATURAL SOUND
STEREO RECEIVER
STANDBY/ON
DISPLAY
MEMORY
AUTO/MAN'L
TIMER
TIMER ADJ
TIMER
BASS
PHONES
–
+
–
Remote control
sensor
Notes
• There should be no large obstacles between the remote control
and the main unit.
• If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp, etc.),
it might cause the remote control not to work correctly. In this
case, reposition the main unit to avoid direct lighting.
Removing the protection sheet
The remote control is shipped with a protection sheet to
prevent the surface from being scratched during
transportation.
When removing the sheet, first put adhesive tape on an
edge of the remote control so that the tape sticks to the
sheet. Then peel the sheet off with the tape.
Note
• Do not scratch the remote control surface when peeling the
sheet off.
2004.06.15, 19:06
VOLUME
RX–E600
PRESET/BAND
PRESET/TUNING
MIN
MAX
HOUR
MIN
INPUT
TREBLE
BALANCE
+
L
R
Within approximately
6 m (20 feet)
3