Yamaha R-S700 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Yamaha R-S700. Yamaha R-S700 10 stron. Electronic drum rack dtx drums

Drukuj stronę
Setting up RS500
1.
Remove the rack from its box and stand it up with the drum trigger module clamp and the left leg positioned on the right
as shown in Figure 1.
2.
With the rack standing up, loosen the bolts q located on the left and rotate the left leg towards you until it is positioned
as shown in Figure 1 Top view.
• The bolts q can be found on the rear of the clamp on the left pillar.
Bolts q
2
Right leg
3.
Loosen the bolts w located on the right in Figure 2 and rotate the right leg clockwise from the left until it comes fully
around as shown in Figure 2 Top view.
• The bolts w can be found on the rear of the clamp on the right pillar.
Drum trigger
module clamp
3
Right leg
Left leg
4.
Tighten the bolts loosened in Steps 2 and 3 above.
2
RS500/RS700 Owner's Manual
Left pillar
2
[Figure 1]
Left pillar
Right pillar
[Figure 2]
Drum trigger
module clamp
Right leg
Right pillar
Left leg
Right leg
Bolts w
[Figure 2 Top view]
CAUTION
• The rack may topple over and cause
injury if the left and right legs are
opened any wider than shown in the
figure below. You should not, there-
fore, exceed the dimensions indicated.
Right pillar
Left pillar
Left leg
2
[Figure 1 Top view]
Left pillar
Right pillar
Left leg
3