Yamaha YHT-693 Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Yamaha YHT-693. Yamaha YHT-693 20 stron. Home cinema speaker package
Również dla Yamaha YHT-693: Instrukcja obsługi (11 strony), Instrukcja obsługi (8 strony)
ADJUSTING THE SUBWOOFER BEFORE USE
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer
and the front speakers by following the procedures described below.
3
1
Set the VOLUME control to minimum (0).
2
Turn on the power of all the other components.
3
Press the POWER switch to the ON position.
* The Power indicator lights up in green.
4
Play a source containing bass signal and adjust the
amplifier's volume control to the desired listening
level.
5
Set the HIGH CUT switch to the LOW or HIGH position.
This subwoofer is designed so that the optimum tone
balance between the subwoofer and the front
speakers is obtained when this switch is set to the
LOW position. The tone balance may change,
however, depending on the room size, the distance
from the subwoofer to the front speakers, and so on.
If necessary, switch it to the HIGH position.
Subwoofer rear panel
OUTPUT
INPUT
HIGH
TO SPEAKERS
2
CUT
/MONO
VOLUME
HIGH LOW
INPUT 1
FROM AMPLIFIER
POWER
ON
OFF
OUTPUT
TO SPEAKERS
INPUT 1
FROM AMPLIFIER
6
Rotate the VOLUME control gradually to adjust the
volume balance between the subwoofer and the other
speakers.
* Normally, set the control to the level where you can
obtain a little more bass effect than when the
subwoofer is not used. If the desired response cannot
be obtained, adjust the HIGH CUT switch and the
VOLUME control again.
Notes
• Once the volume balance between the subwoofer and
the front speakers is adjusted, you can adjust the
volume of your whole sound system by using the
amplifier's volume control.
However, if you change the front speakers to others,
you must make this adjustment again.
• For adjusting the VOLUME control, the HIGH CUT
switch, refer to "Frequency characteristics" on page
10.
1,6
HIGH
INPUT
CUT
2
/MONO
VOLUME
HIGH LOW
5
9