Yamaha AP-U70 Instrukcja konfiguracji - Strona 34

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Wzmacniacz Yamaha AP-U70. Yamaha AP-U70 47 stron. Personal amplifier
Również dla Yamaha AP-U70: Instrukcja serwisowa (46 strony)

Drukuj stronę

Note

When an input selector key is pressed, the display shows the

name of the selected input source for a short while, and then

shows the currently selected sound field program.

When no sound field program is selected, "THROUGH" is

shown on the display.

The names of input sources shown on the display can be changed

with the Application Software. Refer to the Online Help of the

Application Software for details.

To cut off sound output temporarily

Press the MUTE key. To restore sound output, turn the

volume control on the front panel or press the VOLUME

keys on the remote control. Pressing the MUTE key again

also restores sound output.

M U T E

Front panel

Note

Sound output will also be restored by changing the status of this

unit between standby and power-on modes, changing the input

source or the sound field program, using the test tone, or using

the A, B, C keys on the remote control.

When you listen with headphones

Connect the headphones to the headphone jack. No

sound will be outputted from the speakers.

Note

[DP-U50 only]

The PRE OUT terminals on the rear panel will output signals

even if headphones are used.

MUTE

Remote control

When you have finished using this unit

Set this unit to the standby mode by pressing the power

switch on the front panel or the POWER key on the remote

control.

Front panel

Note

When not planning to use this unit for a long period (i.e.,

vacation, etc.), disconnect the AC power plug from the wall

outlet.

Setting USB MIX

When an input other than the USB terminal is selected, you

can listen to the mixed signals from the selected input and

from the USB terminal. Also, the mixing ratio of the signals

from the USB terminal can be adjusted.

* Refer to the online help of the Application Software for details.

Setting graphic equalizer

You can adjust the frequency characteristics as you prefer

by using the 7-band graphic equalizer.

* Refer to the online help of the Application Software for details.

Notes

● Some setting changes may be needed on the computer to

reproduce signals sent from the computer to this unit via the

USB connection. Refer to the separate "SET UP MANUAL"

for details.

● Some setting changes may be needed on the computer to

reproduce signals sent from the computer to this unit via a

sound card, etc.

Automatic power saving function

If there is no operation on this unit's front panel, the

remote control or the Application Software for about 24

hours with the power of this unit on, this unit will

automatically be set to the standby mode.

BASIC OPERATION

POWER

Remote control

E-