Yamaha CX-1000 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Yamaha CX-1000. Yamaha CX-1000 20 stron. Natural sound stereo control amplifier
Również dla Yamaha CX-1000: Instrukcja obsługi (21 strony), Instrukcja obsługi (20 strony), Instrukcja serwisowa (38 strony)

Drukuj stronę

INPUT SELECTOR

To select a source for listening or watching, press sither end

(<Jorf>-) of the INPUT SELECTOR until the desired source

is indicated on the input indicator @.

Input sources can be selected directly with the supplied remote

control unit (see below).

This continuously variable loudness control allows you to

compensate for the human ear's loss of sensitivity to low and

high frequencies at low volumes. It lets you progressively at-

tenuate the middle range in order to retain a natural balance

with the bass and treble when listening at low levels. Normally,

this control should be set to the FLAT position. See below for

operation details.

input indicators

These indicate the source selected with the INPUT SELECTOR

ER Normally, these indicators are red.

However, when the

VIDEO switch @ is on and the audio source selected is different

from the video source, the respective video source indicator

will turn green.

NOTE: č čć

When VIDEO switch on, one of the green video source (VCR :

or CDV) indicators always remains lit, even if you select

an audio source. This means you can listen to the sound

of the selected audio equipment while simultaneously

watching the picture of the indicated video source.

REC OUT selector

Determines which source will be recorded by the connected

tape deck(s), DAT recorder(s) or VCR(s). In the SOURCE

po-

sition, the source currently selected with the INPUT SELECTOR

€) is recorded. Use the SOURCE position when you want to

make an analog recording of a digital signal.

When not recording, leave this rotary switch in the OFF posi-

tion.

Any signals selected with REC OUT (except in the SOURCE

position) are fed directly to the rear panel TAPE OUT,

TAPE/DAT OUT and/or VCR OUT jacks, regardless of the

current INPUT SELECTOR setting. This means you can listen

to or watch any source while recording another.

For details on recording and dubbing, see OPERATIONS.

SOURCE DIRECT switch and indicators

Pressing this switch routes the audio input signal directly to

the CX-1000 output stage, bypassing the tone controls, sub-

sonic filter and the mode, loudness control circuits thus giving

the purest possible sound. lts indicator will light.

Remember

that none of the controls just mentioned will have

any effect when SOURCE DIRECT is pressed, except MUTING.

NOTE:

lf the LOUDNESS control is currently being used, pressing

SOURCE DIRECT will have the effect of suddenly raising the

volume.