Yamaha T3n Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Yamaha T3n. Yamaha T3n 20 stron. Yamaha power amplifier owner's manual
Również dla Yamaha T3n: Instrukcja obsługi (19 strony), Instrukcja obsługi (15 strony), Instrukcja obsługi (19 strony)
Drukuj stronę
Wiring
Turn off the POWER switch before connecting external devices to the amplifier.
■
Using a Euroblock connector
1. If the wire insertion ports are closed, turn the screws on
top of the connector counterclockwise to open the ports.
2. Insert the wires into the appropriate ports, following the
indication of the pole on the input terminal, and turn the
screws on top of the connector clockwise to fix the
wires.
3. Attach the Euroblock connector to the input terminal on
the amplifier.
■
Speaker Connection
● 5-way binding post
1. Remove the cover attachment screws and remove the
protective cover from the speaker terminals.
2. Remove about 15mm of insulation from the end of each
speaker cable, and pass the bare wire through the holes
in the appropriate speaker terminals. Tighten the termi-
nals to securely clamp the wires.
Refer to page 8 for speaker polarities.
Be sure that the bare wire ends do not jut out from the ter-
minals and touch the chassis. The illustration on the right
shows how the cable should look when correctly attached.
3. Reattach the protective cover over the speaker termi-
nals.
● Speakon connector
Insert the Neutrik NL4 plugs into the Speakon connector
on the rear of the amplifier, and turn clockwise to lock.
Å
CHANNEL
STEREO or PARALLEL
Neutrik
Amplifier
1+
A+
1–
A–
2+
B+
2–
B–
10
T5n/T4n/T3n Owner's Manual
BRIDGE
Neutrik
Amplifier
1+
+
1–
2+
–
2–
Speaker
cable
Bare wire
Neutrik NL4 plugs
ı
CHANNEL
Neutrik
Amplifier
1+
B+
1–
B–
Use a screwdriver
to fix the wires.
G
–
+
Screw
* Actual size
Chassis