aerauliqa Quantum EX 100 HT Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wentylator aerauliqa Quantum EX 100 HT. aerauliqa Quantum EX 100 HT 16 stron.

SPEED SETTING
The possible configurations of the minimum, intermediate and maximum speeds are shown in the graphs of
Fig.14 and selectable through the switches as indicated in the DIP SWITCH A Table (Fig.15).
MINIMUM CONTINUOUS SPEED
Upon power-up, the unit runs at the minimum continuous speed.
INTERMEDIATE SPEED
The unit runs automatically at the intermediate speed.
The intermediate speed can be activated when either of the below conditions have been met:
- the humidistat has been activated;
- the run-on timer has been activated.
MAXIMUM SPEED
The maximum speed can be activated through the external switch, remote sensor or light switch. The led
on the front cover support lights up.
HUMIDISTAT
The unit is equipped with a humidity sensor that operates in AUTO mode, i.e. the humidistat, which records
the humidity levels, triggers if there is a steep variation of the humidity and if humidity level is over 65%.
If the humidistat is activated, the unit runs at the intermediate speed and continues to run for a fixed time of
5 minutes after the umidity level stabilizes.
The humidistat can be enabled/ disabled by means of switch 2 of Dip Switch B (Fig.15).
RUN-ON TIMER
The unit is equipped with a run-on timer. When the external switch is turned off, the unit continues to run at
the intermediate speed for the a period of time defined as follows:
- if the external switch is activated for less than 3 minutes, the unit does not run-on;
- if the external switch is activated for between 3 and 10 minutes, the unit runs on for 5 minutes;
- if the external switch is activated for between 10 and 20 minutes, the unit runs on for 10 minutes;
- if the external switch is activated for over 20 minutes, the unit runs on for 15 minutes.
When the time is expired, the unit returns to the minimum continuous speed.
The run-on Timer can be enabled/disabled by means of switch 3 of Dip Switch B (Fig.15).

DISPOSAL AND RECYCLING

Information on disposal of units at the end of life.
This product complies with EU Directive 2002/96/EC.
The symbol of the crossed-out dustbin indicates that this product must be collected separately
from other waste at the end of its life. The user must, therefore, dispose of the product in question
at suitable electronic and electro-technical waste disposal collection centres, or else send the
product back to the retailer when purchasing a new, equivalent type device.
Separate collection of decommissioned equipment for recycling, treatment and environmentally
compatible disposal helps to prevent negative effects on the environment and on health and
promotes the recycling of the materials that make up the equipment.
Improper disposal of the product by the user may result in administrative sanctions as provided
by law.
7