Yamaha ATS-1010 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Yamaha ATS-1010. Yamaha ATS-1010 19 stron. Front surround system
Również dla Yamaha ATS-1010: Instrukcja obsługi (20 strony)

Yamaha ATS-1010 Instrukcja obsługi
FCC INFORMATION
(for US customers)
1
IMPORTANT
NOTICE:
DO NOT MODIFY
THIS
4
UNIT!
This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirements.
Modifications
not expressly approved by
Yamaha may void ynur authority, granted by the FCC,
to use the product.
5
IMPORTANT:
When connecting
this product to
accessnries
and/or another product use only high
6
quality shielded cables. Cable/s supplied with this
product MUST be used. Follow all installation
instructions.
Failure to lollow instructions
could void
7
your FCC authorization
to use this product in the USA.
NOTE:
This product has been tested and lonnd to
comply with the requirements
listed in FCC
8
Regulations,
Part 15 for Class "B" digital devices.
Compliance
with these requirements
prnvides a
reasonable
level of assurance that your use of this
product in a residential environment
will not result in
harmfnl interference
with other electronic devices.
This equipment generates/uses
radio fl'equencies and,
9
if nnt installed and used according tn the instructions
found in the users manuah may cause interfi_rence
harmful tn the operation nf other electrnnic devices.
Compliance
with FCC regulations
does not guarantee
that interfi_rence will nnt occur in all installations.
If
this product is found to be the snnrce nf interli_rence,
which can be determined by turning the unit "OFF"
and "ON", please try to eliminate the problem by using
one of the lollnwing measures:
Relocate either this product or the device that is being
affected by the interli_rence.
Utilize power outlets that are on difli_rent branch
(circuit breaker or fuse) circuits or install AC line
filter/s.
In the case of radio or TV interference,
relocate/
reorient the antenna. If the antenna lea&in is 300 ohm
ribbon lead, change the lead=in to coaxial type cable.
If these corrective measures do not produce
satislactnry
results, please contact the local retailer
authorized to distribute this type of product. If you can
not locate the appropriate retailer, please contact
Yamaha Electronics Corp., U.S.A. 6660 Orangethnrpe
Ave., Buena Park. CA 90620.
The above statements
apply ONLY to those products
distributed
by Yamaha Corporation of America or its
subsidiaries.
We Want You Listening For A Lifetime
Yamaha and the Electronic
Industries Association's
Consumer
Electronics
Group want you to get the
most out of your equipment
by playing
it at a safe level. One that lets the sound come through
loud
and clear without
annoying
blaring or distortion
- and, most imporlantly,
without
affecting
your
sensitive
hearing.
Since hearing damage
from loud sounds is olden undetectable
until it is too late,
Yamaha
and the Electronic
Industries Association's
Consumer
Electronics
Group recommend
you to
LISTENING
Fo_ALiletime
avoid prolonged
exposure
from excessive
volume levels.
ii En