Yamaha DSP-E200 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Yamaha DSP-E200. Yamaha DSP-E200 19 stron. Natural sound digital sound field processor

Drukuj stronę

SPEAKER CONFIGURATIONS FOR THIS UNIT

SPEAKERS TO BE USED

This unit is designed to provide the best sound-field quality with 5 speaker configuration. The speakers to be used with this unit will

be mainly front speakers, rear speakers, and a center speaker. (You can delete a center speaker. Refer to the "4-Speaker

Configuration" shown below.)

The front speakers are used for the output of the main source sound and the effect sound. They will probably be your present

stereo speaker system. The rear speakers are used for the output of the effect sound. And the center speaker is used for the

output of the center sound (dialogue etc.) encoded with the Dolby Surround. The rear and center speakers do not need to be equal

with the front speakers. However, all the speakers should have high enough power handling to accept the maximum output of this

unit that will drive them.

SPEAKER CONFIGURATION

5-Speaker Configuration

This configuration is the most effective and recommended. In

this configuration, the center speaker is necessary as well as

the rear speakers. If the digital sound field program is in the

DOLBY PRO LOGIC or ENHANCED, conversations will be

output from the center speaker and the ambience will be

excellent.

* Set the center mode to the "NORMAL" or "WIDE" position.

(For details, refer to the page 11.)

Front L

Dialogue

Surround sound

Rear L

SPEAKER PLACEMENT

The recommanded speaker configuration, the 5-speaker configuration, will require two speaker pairs: front speakers (your normal

stereo speakers), and rear speakers, plus a center speaker. When you place these speakers, refer to the following.

Front R

Center

Front L

TV set

Center

Front R

Rear R

Rear L

4-Speaker Configuration

The center speaker is not used in this configuration. If the

digital sound field program is in the DOLBY PRO LOGIC or

ENHANCED, the center sound is output from the left and the

right front speakers. However, the sound effect of other

programs can be the same as that of the 5-speaker

configuration.

* Be sure to set the center mode to the "PHANTOM" position.

(For details, refer to the page 11.)

Front L

Dialogue

Surround sound

Rear L

Front:

In normal position. (The position of your present

stereo speaker system.)

Rear:

Behind your listening position, facing slightly inward.

Nearly six feet up from the floor.

Center: Precisely between the front speakers. (To avoid

interference to TV sets, use a magnetically shielded

speaker. If, however, it is not effective, keep the

speaker away from TV sets.)

Front R

Rear R