Yamaha DSP-E390 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Yamaha DSP-E390. Yamaha DSP-E390 16 stron. Natural sound digital sound field processor

Drukuj stronę
Yamaha DSP-E390 Instrukcja obsługi
7
Turn up the volume.
You will hear a test tone (like pink noise) from the left front
speaker, then the center speaker, then the right front
speaker, and then the rear speakers, for about two
seconds each. The display changes as shown below.
Front (L)
Center
Rear
Front (R)
(L and R)
* The test tone from the left rear speaker and the right rear
speaker will be heard at the same time.
8
Adjust the sound output level of the center speaker to be
at the same level as that of the front speakers with the
CENTER LEVEL control.
CENTER LEVEL
10
7
8 9
DELAY
NORMAL
WIDE
PHANTOM
ms
TEST
0
I 0
PRO LOGIC
ROCK
10
TEST
DELAY
TIME
+
–
9
Adjust the sound output level of the rear speakers to be
at the same level as that of the front speakers with the
REAR LEVEL control.
REAR LEVEL
10
Cancel the test tone.
TEST
Notes
Once you have completed these adjustments, you can
adjust whole sound level on your audio system by using
the VOLUME control (or the MASTER VOLUME keys on
the remote control transmitter).
If you use external power amplifiers, their volume controls
may also be adjusted to achieve proper balance.
In step 8, if the center channel mode is in the "PHANTOM"
position, the sound output level of the center speaker
cannot be adjusted. This is because in this mode, the
center sound is automatically output from the left and right
front speakers.
If there is insufficient sound output from the center and
rear speakers, you may decrease the front channel output
level by setting the FRONT LEVEL switch on the rear
panel to "–10 dB".
TAPE MONITOR
PROGRAM
—
ENHANCED
CNCT VIDEO
MONO MOVIE
SUR.
HALL
ON/OFF
EFFECT
CENTER MODE
MASTER
VOLUME
+
7
–
0
I 0
NORMAL
WIDE
PHANTOM
ms
TEST
Stops flashing and disappears.
11