ABB MPS-C 2000 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenie zabezpieczające ABB MPS-C 2000. ABB MPS-C 2000 18 stron. Microprocessor-based protection and metering devices for low voltage power circuit breakers
Również dla ABB MPS-C 2000: Skrócona instrukcja obsługi (8 strony)
Drukuj stronęABB
IB 6.1.2.8-1B
Page 8
5.
MPS-C 2000 SETUP INSTRUCTIONS
5.1
General Instructions
5.1.1 The front panel keypad consists of four directional arrow keys, a cancel key, an enter key, and an LCD
window.
5.1.2 When the MPS-C 2000 unit is connected to a power source, an initial title screen is displayed in the LCD
window.
This screen display is replaced after approximately three seconds by a setup screen.
Subsequent Main Menu screens are accessed by pressing the "E" key and the up and down keys. See section 6.
5.1.3 Each Main Menu has a Submenu, used for entering and displaying values. These are accessed by pressing
the "E" key while in the Main Menu. The up and down keys are used in the submenus to display the desired type of
values or settings and the "E" key is pressed again to access these. The up and down keys are then used to scroll
through the settings.
5.1.4 Pressing the "C" key in any screen will back up the display to the previous screen.
Courtesy of NationalSwitchgear.com