Clark Synthesis Prosound429 Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przetwornik Clark Synthesis Prosound429. Clark Synthesis Prosound429 9 stron.

STAGE/PLATFORM INSTALLATION

There are at least two ways to mount a Prosound429 to a stage or platform. For wooden stages, you can install

a bridge between support joists of the staging. For metal frame staging or freestanding wooden platforms

you can install the mounting bracket directly to the staging surface. Either of these types of installation are

effective for activating the stage's/platform's surface.

NOTE: The Prosound429 designed to be mounted in a horizontal orientation. Mounting the

Prosound429 vertically may cause premature failure.

For a more permanent installation on wooden stages, you may want to use the bridge mount method.

Determine which type of bridge you want to use (straight or arched). If you are using the arched

bridge style, cut the arch using the dimensions shown below (CAUTION: DO NOT CUT INTO EXISTING

JOISTS).

Cut the length of the bridge board to fit snugly between the two support joists. The bridge board

must be at least 3/4" (1.9 cm) thick. Screw the bridge board securely between the support joists. Drill

a 5/16" (.79 cm) pilot hole that is approximately 2 inches (5 cm) deep into the joist.

Place two (2) Jam Nuts on the Hanger Bolt and tighten the nuts together (this will allow you to turn

the bolt with a wrench). Turn the Hanger Bolt into the joist up to the place on the bolt where the

threads change from wood threads to machine threads. Loosen and remove one of the Jam Nuts.

Prosound429

CORRECT

Bridge Mount

Arched Bridge

CORRECT

INCORRECT

` loob`q

3" (7.6 cm)

5-1/2" (14 cm)

Jam Nut

g~ã=kìí

fk` loob`q

Straight Bridge