Directed Directechs DB3 Instrukcja instalacji - Strona 11

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

IMPORTANT!

Before programming your module, you must first check if your vehicle is equipped with an OEM remote

starter and disable it. If the vehicle is equipped with an OEM remote starter, whether Active or Inactive, it

temporarily disabled or permanently disconnected depending on the vehicle.

Please refer to the "OEM remote starter information" section of the guide for additional details.

Note:

In some cases, the module will program to the vehicle even if equipped with an OEM starter, but will prevent the

aftermarket remote start from functioning properly.

Wait until the LED turns ON solid red.

Note: To skip the transponder programming and use convenience features only, press

the programming button 5 times. The LED will turn orange then proceed to step 2.

Press the Push-to-Start (PTS) button twice to turn the ignition ON. The LED turns ON

solid green for 3 seconds, then shuts OFF*.

* The LED flashes orange if an OEM remote starter has been detected. Refer to "OEM

starter detection" for more information.

Note: If the transponder programming was skipped, the LED turns ON solid orange for

3 seconds then shuts off when programming is done.

Press the PTS button once more to turn vehicle ignition OFF, once the module is

successfully programmed.

You have successfully completed the module programming sequence.

403.TL2 4.15 2019 Lexus GX 460 (Smart Key)

MUST