Caliber CALNAV Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla GPS Caliber CALNAV. Caliber CALNAV 13 stron. Global positioning system
Drukuj stronęGPS (GLOBAL POSITIONING SYSTEM)
Starting Navigation
1.Switch on your navigation system.
2.The navigation software starts
automatically or after tapping the
navigation control button, depending
on the product version.
3.Tap the button to enter the destination
and the address of your navigation
destination. Then start the navigation
by tapping Navigate. After a short time
- if the satellite reception is adequate
- you will receive the route information
on the screen, augmented by voice
instructions.
For further operation of the navigation
software, please refer to the
comprehensive user handbook on the
navigation CD.
In addition, brief help is available to you
on your navigation system. You can reach
it by tapping the Options/ Destination
Entry button and then selecting the help
function.
Note: When the GPS-receiver is used for
the first time, it will require some minutes
for initialization. Even if GPS signal
reception is indicated, the navigation could
be imprecise. In all future instances it will
only take about 30-60 seconds until a
correct GPS signal is available; this,
however, requires a sufficient "sight" of
the satellites.
Installing Software on Your PC
In order to be able to use self-defined
maps on your navigation system you must
install the corresponding navigation
software on your PC.
1.Before installing the navigation software
ensure that ActiveSync is installed and
your navigation system is connected
to your PC via the ActiveSync cable.
2.Insert CD 1 with the navigation software
in your CD-ROM drive. The installation
starts automatically.
3.Follow the instructions on the screen.
Content of the Navigation CDs
It may be possible that several CDs are
supplied, depending on your product
version.
Content of the CDs:
CD 1 contains the PC application,
digitalised map material and data for fast
restoring the content of the memory card.
Additional material on the card is stored
on CD 2 (optional). The PC application
will be installed on the computer and used
to set up your own map details. Apart
from this, it will support the recreation of
data on the memory card.
Installing Microsoft ActiveSync
To transfer your data between your PC
and your navigation system you need the
Microsoft ActiveSync programme.
The purchase of the navigation system
includes a license for this programme,
which can be found on the support CD.
Attention: Important files can be
overwritten or changed during software
installation. You should create a hard disk
backup, in order to be able to have access
to the original files in case of possible
problems following the installation.
You must have administrator rights to
install the software under Windows
2000/XP.
Attention: You should not connect the
navigation system to your computer yet.
1.Insert the support CD and wait until the
programme starts automatically.
Note: If it does not start automatically,
the Auto Run function is probably
deactivated. Then you have to start the
setup programme on the CD manually.
2.Choose the language, then click on
Install ActiveSync and follow the
instructions on the screen.
3.While the connection options are
checked, use the ActiveSync cable to
connect the navigation system to your
computer. To do this, plug the USB
connector into the USB port of your
computer.
The hardware installation assistant now
recognises a new device and installs a
suitable driver, which can take some
minutes. Repeat the connection search
if it fails the first time.
4.Follow the instructions on the screen.
The programme will now set up a
partnership between your PC and the
device.
13