Clarke 3110550 Instrukcja obsługi i konserwacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke 3110550. Clarke 3110550 17 stron. Air shears

OPERATION

OPERATING THE AIR SHEAR

1. Place the cutter head against the

side of the sheet metal you want

to cut.

2. Squeeze the trigger to start the

metal shear.

3. Maintain constant pressure to

move the tool through the sheet

metal.

4. Release the trigger switch to stop

the metal shear.

WORKING AT AN ANGLE

The shears can be set to operate in

line with the handle or at an angle, for

example, if working in a confined

space.

1. To do this, re-set the nose section in

its new position by slackening the

hex screw shown using the key,

and rotating the nose assembly to

the angle required.

• It can be set at any angle

required.

2. Ensure you have re-tightened the screw before using the shear.

Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

1. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

2. Once the pressure has been released, disconnect the air supply hose from

the air drill.

3. Store the tool safely in its box in a dry, secure environment.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]