Clarke 4500633 Instrukcja obsługi i konserwacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke 4500633. Clarke 4500633 17 stron.

• If charging does not take place,

ensure all connections are clean

and free of grease etc.

• If the red charging light will not stay

on for more than a few moments,

the battery pack is likely to be

defective and it must be replaced

with a new one.

• When charging is complete

(typically after about 1/2 hour), the

RED charging light goes off and the

green light turns back on. The

battery pack can be considered

charged and be removed. The

charging time will be dependant

upon the initial state of the batteries.

• When charging a new battery pack it may initially not accept full

charge. This is common & does not indicate a fault. It can be

recharged fully after it has been discharged a couple of times.

6. After charging, switch off and unplug the charger from the power supply.

7. Remove the battery pack from the charger and slide it back into the

machine until it clips into place.

The battery pack should slide in easily.If the battery pack is not to be fitted

immediately, ensure that the metal contacts are protected so as to avoid the

possibility of a short circuit which would cause damage.

Remember to avoid extremes of heat or cold when charging. Avoid

temperatures outside the range of Minimum 4°C /Maximum 50°C. Avoid

placing batteries in direct strong sunlight or other heat source.

NOTE: Ni-Cad batteries as used in Clarke cordless power tools should be

given a full charge when first supplied new. Maximum battery

performance will be achieved after approximately 5 complete

charge/discharge cycles.

NOTE: The battery should be fully discharged before recharging in order

to achieve its optimum performance. Constant topping up after

only a small amount of charge has been used will, in effect,

reduce its capacity.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]