Directed Directechs DB3 Instrukcja instalacji - Strona 19

Drukuj stronę

Directed Directechs DB3 Instrukcja instalacji

Quick Reference Guide (customer copy)

Sending commands to your vehicle

Whether you want to remote start the engine, lock/unlock the doors or pop the trunk, there

are 3 possible ways you can send commands to your vehicle, using the:

Factory remote.

2. Aftermarket remote.

3. Directed SmartStart

application via your smartphone.

If applicable, you can also start the engine remotely by pressing the Lock button 3 times

quickly on your factory remote.

Important: Wait at least 2 seconds before restarting the engine or an error message

can appear on the vehicle information display.

The Vehicle takeover feature is not available on the following vehicles:

•

2022 Honda Civic (Smart Key)

•

2023 Honda CR-V (Smart Key)

•

2023 Honda HR-V (Smart Key)

The engine will shut down as soon as a door is opened.

Vehicle takeover with Get In and Go

Close the vehicle doors, hood and trunk, then press

the Remote Start button on the transmitter to start the

vehicle.*

Press the Unlock button on the factory or aftermarket

remote.*

Complete the following steps within 45 seconds or the vehicle will shut down.

Enter the vehicle, while making sure the factory remote is

inside with you.

Depress the brake pedal for a minimum of 3 seconds, put

the car in gear and drive off.

For Manual Transmission, press and hold the clutch first,

then depress the brake pedal for a minimum 3 seconds.

* Icon and remote appearance may differ depending on the model purchased.

403.HONDA9 2.07 2023 Honda Civic (Smart Key)

Get In and Go

Get In and Go is designed to provide users with easy takeover when entering their Push-to-

Start (PTS) equipped vehicle, once it has been remote started.

Typically, users would have to remote start their vehicle, then get inside and press the PTS

button to perform a takeover. There is therefore a physical action required to drive away.

With Get In and Go, you simply remote start the vehicle, unlock the doors, get in and go...

All that's left to do is put the gear in drive and drive off.

Pit stop/idle mode

Stop the vehicle in a safe parking spot and put the gear

in Park (P).

Press the Remote Start button on the transmitter.*

The parking lights will flash once to indicate the vehicle is

now in Pit Stop Mode.

Exit the vehicle with the factory remote in hand (it is safe

to leave the engine running).

Notes: We recommend that you always lock the doors of

your vehicle when leaving it unattended.

Press Remote

Start button*

* Icon and remote appearance may differ depending on the model purchased.

Press Unlock on

either remote*

14:36

Enter vehicle

with remote

Ready to

drive off

14:36

Put

gear in

Park

Parking lights flash x1

Press Remote

Start button*

14:36

Exit vehicle

with remote