Clarke 7617000 Instrukcja obsługi i konserwacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Elektronarzędzie Clarke 7617000. Clarke 7617000 17 stron. Body repair kit

MAINTENANCE

If the pump has been stored for long

periods, check the oil level before

use. Stand the pump on a level

surface and remove the breather

valve on the oil reservoir. If necessary,

top up via the breather valve which is

then screwed on finger tight.

NOTE: Only unscrew this when the

system is not under pressure.

The oil level should be near the

bottom of the opening. If required, oil can be topped top using Clarke

Hydraulic Oil. (part no. 3050830 for 1 litre).

After extensive use, the hydraulic oil should be replaced to ensure longer

equipment life. Do not overfill, or the piston rod will be unable to move freely.

Replace the breather valve after re-filling. The required oil volumes are as

follows.

• CS4BRK - 250 ml + 5ml

• CS10BRK/CS10SBRK - 500 ml + 5ml

STORAGE

After use, screw the valve cover on

to the pump to keep the connection

clear of dust and dirt and cover the

hydraulic hose end with the plastic

cap.

When not in use, the pump should be

stored with the release valve open.

Store all the equipment in its case in a

clean, dry environment protected

from the weather.

ENVIRONMENTAL PROTECTION

One of the most damaging sources of environmental pollution is oil products.

Never throw away used hydraulic oil with domestic refuse or flush it down a

sink or drain. Collect any hydraulic oil in a leak proof container and take it to

your local waste disposal site.

If disposing of this product or any damaged components, do not dispose of

with general waste. This product contains valuable raw materials and should

be taken to your local civic amenity site for recycling of metal products.